I am making a terminal program that uses fgets() to get user input. The problem now is that after the user enters data, the input data cannot be modified. If "
#include
#includeint test_termios() { st...
The teacher asked us to design an amplifier circuit based on an integrated operational amplifier with adjustable magnification (1, 10, 100), and the magnification can be controlled by the MCU. But I a...
By setting the PCI register, 256M memory space is memory mapped. Can this 256M memory space be used for DMA transfer? How to convert physical address and linear address?...
Dear brothers: I am now looking at Zhou Ligong's IIC driver code. Under the IIC driver code, an interrupt thread can be created to enter the interrupt. However, another WINCE driver document about IIC...
Do the ADC channels in stm32 adc scan mode have to be continuous? For example, setting them to ADC_Channel_1, ADC_Channel_3, ADC_Channel_5, are non-continuous channels OK?...
The production process of capillary tube: cutting tube---powder coating---molding (spiral and straight tube, straight tube is divided into bent tube and bridge, bridge after baking)---baking---sealing...
A single-chip microcomputer is also called a single-chip microcontroller. It is not a chip that completes a certain logical function, but a computer system integrated into one chip. In general, a c...[Details]
1. Introduction
RFID (radio frequency identification) is a non-contact automatic identification technology that emerged in the 1990s. It uses the characteristics of radio frequency signal prop...[Details]
introduction
my country has a vast territory and a large population. The scale of housing construction is huge, and the amount of residential construction is large and wide. It is still on t...[Details]
Microcontrollers (MCUs), which are widely used in automotive electronics, are rapidly facing time and cost pressures. The main advantage of using MCUs has always been to create high-level system in...[Details]
All electronic design engineers and scientists have performed electrical signal analysis, or signal analysis for short. Through this basic measurement, they can gain insight into signal details and...[Details]
In this article, the high-performance DSP developed by TI can be used as an effective confidentiality method if it is applied to PC encryption cards.
As an effective network security solution,...[Details]
In recent years, lighting has become an important area that countries around the world are targeting to promote energy conservation and environmental protection. According to statistics, about 20% ...[Details]
Electronic systems are located at different points on the automotive power bus and therefore often need to operate under very stringent power requirements. These include load dump, cold crank, very lo...[Details]
With the continuous improvement of the requirements of intelligent building security systems and the continuous improvement of people's safety awareness, indoor anti-theft has gradually attracted peop...[Details]
1. Introduction
At present, most lighting equipment still uses traditional energy for lighting. Making full use of solar energy as the energy supply for lighting equipment is of great si...[Details]
Contact resistance
is the resistance to current flow through a closed pair of contacts. This type of measurement is performed on devices such as connectors,
relays
, and switches. The...[Details]
Overview:
This paper introduces a method of connecting a CAN-bus network with Ethernet to form a medium-sized remote monitoring/data transmission network.
CAN (Controller Area Network) is ...[Details]
1 Introduction to HART Protocol
HART (Highway Addressable Remote Transducer), an open communication protocol for addressable remote sensor high-speed channels, was launched by Rosemen in the U...[Details]
1. Introduction
Testing the temperature of steel billets before rolling is an important measure to ensure the quality of steel. Traditional manual testing is difficult to ensure product qu...[Details]
Many battery-powered systems require a visual indicator to show when the battery needs to be replaced. LEDs are commonly used for this purpose, but they consume at least 10mA of current. This con...[Details]
Embedded System
京公网安备 11010802033920号
EEWORLD
