WLS1A01Q5BT3 datasheet, PDF - EEWORLD Datasheet

Datasheet> All Categories > WLS1A01Q5BT3

Preview

WLS1A01Q5BT3: DescriptionLimitlessâ¢ Single Switch Adapter; File Size2MB，47 Pages; ManufacturerHoneywell; Websitehttp://www.ssec.honeywell.com/

Download Datasheet View All

WLS1A01Q5BT3 Overview

Limitlessâ¢ Single Switch Adapter

Preview

Download Datasheet

View All

Installation and Technical Manual for the

Limitless™ Series WDRR Receiver

50063987

ISSUE 5

WARNING

•

DO NOT USE these products as safety or emergency

stop devices or in any other application where failure of

the product could result in personal injury.

Failure to comply with these instructions could result in

death or serious injury.

PERSONAL INJURY

•

The WDRR must be installed in accordance with the

requirements specified in this document in order to comply

with the specific Country Communication Agency

requirements. (i.e. FCC, IC, ETSI, ACMA, etc.) See

Section 3 as it requires choosing the correct Country Use

Code and thus allowable antenna and/or cable usage.

WARNING

Honeywell does not recommend using devices for critical

control applications where there is, or may be, a single point

of failure or where single points of failure may result in an

unsafe condition. It is up to the end-user to weigh the risks

and benefits to determine if the products are appropriate for

the application based on security, safety and performance.

Additionally, it is up to the end-user to ensure that the

control strategy results in a safe operating condition if any

crucial segment of the control solution fails.

Honeywell customers assume full responsibility for learning

and meeting the required Declaration of Conformity,

Regulations, Guidelines, etc. for each country in their

distribution market.

Failure to comply with these instructions could result in

death or serious injury.

•

Pay attention to ESD discharge at dc-in port.

WARNING

•

Korean Communication Commission does not allow this

equipment to be used for rescue service.

•

Anatel states that this device works as a secondary

function model. It may not be used as a protection device

against harmful interference. It cannot cause interference

with systems that are running as primary function.

WARNING

CAUTION

* Power to the WDRR should not be applied during

installation of antenna as damage could occur to the

WDRR electronics.

WARNING

•

To satisfy FCC RF exposure requirements for mobile

transmitting devices, a separation distance of 20 cm or

more should be maintained between the antenna of this

device and persons during device operation To ensure

compliance, operation at closer than this distance is not

recommended. The antenna used for this transmission

must not be co-located in conjunction with any other

antenna or transmitter.

Failure to comply with these instructions could result in

death or serious injury.

RF EXPOSURE

CAUTION

* The WDRR receiver offers optimal performance when

paired with Limitless™ inputs that have a firmware

version of 7170 or a greater number (i.e., FW7170 will be

printed on the Limitless™ input label). If the Limitless™

input is paired with older firmware (FW7170 or a lesser

number), the WDRR may exhibit delayed responses

under simultaneous operation.

Sensing and Productivity Solutions

Limitless™

WDRR Receiver

IST OF

IGURES

Issue 5

50063987

Figure 1. European Declaration of Conformity (DoC)

.................................................................................................. 9

Figure 2. Limitless™ WDRR DIN Rail Receiver with location call-out

....................................................................... 12

Figure 3. Limitless™ WDRR DIN Rail Receiver with WDRRPWRASM connected

................................................... 13

Figure 4. Limitless™ Switch Housing

........................................................................................................................ 20

Figure 5. Limitless™ WDRR Housing

........................................................................................................................ 20

Figure 6. Limitless™ Switch with Function Button Depressed

.................................................................................. 20

Figure 7. Limitless™ Switch Label Placement

........................................................................................................... 20

Figure 8. Limitless™ WDRR Operation and LED Functions Chart

............................................................................ 22

Figure 9. Radiation Pattern of an Omni-directional Antenna

..................................................................................... 25

Figure 10. Limitless™ switch to WDRR Antennas with RF Signal Line of Sight (LOS) Free From Obstacles

......... 26

Figure 11. Limitless™ switch to WDRR Antennas with RF Signal Line of Sight (LOS) Affected by

......................... 26

Figure 12. Limitless™ WDRR RP-SMA Connection, Integral

.................................................................................... 28

Figure 13. Limitless™ WDRR RP-SMA Connection, Remote

................................................................................... 28

Figure 14. Straight, Right-Angle, and Tilt-and-Swivel antennas

................................................................................ 28

Figure 15. Adhesive Mount Antenna – Step 1. Pre-clean the surface

...................................................................... 29

Figure 16. Adhesive Mount Antenna – Step 2. Peel Protection from Adhesive Strip................................................

Figure 17. Adhesive Mount Antenna – Step 3. Mount the Antenna...........................................................................

Figure 18. Mast Mount Antenna – Tighten nut on mounting bracket

...................................................................... 30

Figure 19. Mast Mount Antenna – Side View with Attachment to Pipe

.................................................................. 30

Figure 20. Magnetic Mount Base with Antenna – Mounted on Steel Surface

.......................................................... 31

Figure 21. WAN09RSP Magnetic Mount Antenna

..................................................................................................... 31

Figure 22. WAN10RSP Magnetic Mount Antenna

..................................................................................................... 31

Figure 23. Through-hole mount antenna

.................................................................................................................... 31

Figure 24. Highest RF signal when antennas are as parallel to each other as possible (parallel arrangement

shown with the Limitless™ WPMM monitor and WGLA switch)

................................................................................ 32

Figure 25. Limitless™ WDRR Mounting Clips

........................................................................................................... 35

Figure 26. Limitless™ WDRR Mounting Tabs

............................................................................................................ 35

IST OF

ABLES

Table 1 –Table of Abbreviations and Definitions

.......................................................................................................... 2

Table 2 –Table Symbol Definitions

............................................................................................................................... 3

Table 3 – North America; Country Use Code “A”

........................................................................................................ 4

Table 4 – Asia Pacific; Country Use Code “B”

............................................................................................................ 4

Table 5 – European Union; Country Use Code “B”

..................................................................................................... 4

Table 6 – Other European Countries; Country Use Code “B”

..................................................................................... 4

Table 7 – Approvals and Ratings

................................................................................................................................. 5

Table 8 – Radio Module Specifications

....................................................................................................................... 5

Table 9 – Electrical Specifications

............................................................................................................................... 5

Table 10 – Environmental Specifications

..................................................................................................................... 6

Table 11 – Country Use Code A Antenna Options

..................................................................................................... 10

Table 12 – Country Use Code B Antenna Options.....................................................................................................

sensing.honeywell.com

Recommended Resources

DK-5Db DC power supply control circuit

Pulse, triangle wave and sawtooth wave signal generator circuit using 566 02

800w dimmer circuit

AD converter 5G7135 liquid crystal display circuit

HDSL line driver circuit

555 mine dust removal delay photoelectric controller circuit

The PCB design of the industrial "safety" control system based on Hercules is completed: The PCB design of the industrial "safety" control system based on Hercules takes a long time to complete!...; 蓝雨夜 Microcontroller MCU

TNND has recently cracked down on spam, boring, and censored replies.: RT I was deleted by someone recently and I am so depressed. If I find it again, I will just apply for the ID to be blocked to save trouble. . . I don’t know if this is the legendary: First the militar...; liu0911 Embedded System

The 2019 STM32 National Tour Seminar is about to start. Register now to win three gifts: The 2019 ST National Tour Seminar will be launched in 13 cities ( Beijing, Hangzhou, Chengdu, Hefei, Shenzhen, Xi'an, Nanjing, Shunde, Changsha, Jinan, Xiamen, Shanghai, and Guangzhou ) from September...; EEWORLD社区 Robotics Development

Create a process--exec function: #include #include #include int main(void) { char *args[] = {"/bin/ls", NULL}; if(execve("/bin/ls", args, NULL) == -1) { perror("execve"); exit(EXIT_FAILURE); } puts("shouldn't get here"); exit(EXIT_SU...; qinkaiabc Programming Basics

Op amp design handbook: The most authoritative op amp design information...; libiao775 Analog electronics

求助：請問入門之後想進一步學習FPGA應該買那一塊的開發板: I use Verilog HDL...; 1067941083 FPGA/CPLD

Shortcut: A0 A1 A2 A3 A4 A5 A6 A7 A8 A9 AA AB AC AD AE AF AG AH AI AJ AK AL AM AN AO AP AQ AR AS AT AU AV AW AX AY AZ B0 B1 B2 B3 B4 B5 B6 B7 B8 B9 BA BB BC BD BE BF BG BH BI BJ BK BL BM BN BO BP BQ BR BS BT BU BV BW BX BY BZ C0 C1 C2 C3 C4 C5 C6 C7 C8 C9 CA CB CC CD CE CF CG CH CI CJ CK CL CM CN CO CP CQ CR CS CT CU CV CW CX CY CZ D0 D1 D2 D3 D4 D5 D6 D7 D8 D9 DA DB DC DD DE DF DG DH DI DJ DK DL DM DN DO DP DQ DR DS DT DU DV DW DX DZ

Popular Components