The DS1099 is a low-cost, low-power, low-frequency
silicon oscillator that generates two square-wave out-
puts with frequencies between 0.25Hz and 1.048MHz.
Individual output enables allow both outputs to be
enabled/disabled independently. Both outputs are
capable of sinking 16mA, allowing them to directly
interface to light-emitting diodes (LEDs) as well as other
external circuitry. The DS1099 operates over a wide
supply voltage, making it suitable for both 3V and 5V
systems. The device is shipped from the factory custom
programmed and calibrated, ready to be inserted into
the end application.
Contact the factory for custom frequencies or require-
ments.
Features
♦
Low-Cost, Low-Frequency EconOscillator™ with
Dual Outputs
♦
Factory Programmed
♦
Output Frequencies Independently Programmable
from 0.25Hz to 1.048MHz
♦
2.7V to 5.5V Single-Supply Operation
♦
No External Timing Components Required
♦
Independent Output Enables
♦
CMOS/TTL-Compatible Outputs
♦
Oscillator Outputs Capable of Sinking 16mA to
Directly Drive LEDs
♦
Relieves Microprocessor of Periodic Interrupt
♦
Low-Power Consumption
♦
Operating Temperature Range: -40°C to +85°C
♦
±100ppm/°C Temp Drift (MAX)
DS1099
Applications
Flashing LED Status Indicators
Consumer Appliances
Automotive
Servers
Printers
Switch-Mode Power Supplies
Ordering Information
PART
DS1099U-α
0
α
1
*
TEMP RANGE
-40°C to +85°C
PIN-PACKAGE
8 µSOP
*Where
α
0
and
α
1
specify the factory programmed divider set-
tings for OUT0 and OUT1, respectively.
Ordering information is continued on the last page.
EconOscillator is a trademark of Dallas Semiconductor.
Typical Operating Circuit
V
CC
V
CC
Pin Configuration
TOP VIEW
V
CC
OE0
OE1
N.C.
N.C.
OUT1 1
OUT0
OUT1
OUT0
V
CC
2
3
8
7
N.C.
N.C.
OE1
OEO
DS1099
GND
DS1099
6
5
GND 4
OE1 CAN INSTEAD
BE TIED TO V
CC
IF OUT1 IS NOT USED.
OUTPUTS CAPABLE OF
SINKING 16mA
µSOP
______________________________________________
Maxim Integrated Products
1
For pricing, delivery, and ordering information, please contact Maxim/Dallas Direct! at
1-888-629-4642, or visit Maxim’s website at www.maxim-ic.com.
Low-Frequency Dual EconOscillator
DS1099
ABSOLUTE MAXIMUM RATINGS
Voltage Range on V
CC
Relative to Ground ...........-0.5V to +6.0V
Voltage Range on
OE0
and
OE1
Relative to Ground.................................-0.5V to (V
CC
+ 0.5V),
not to exceed 6.0V
Operating Temperature Range ...........................-40°C to +85°C
Storage Temperature Range .............................-55°C to +125°C
Soldering Temperature .......................................See IPC/JEDEC
J-STD-020A Specification
Stresses beyond those listed under “Absolute Maximum Ratings” may cause permanent damage to the device. These are stress ratings only, and functional
operation of the device at these or any other conditions beyond those indicated in the operational sections of the specifications is not implied. Exposure to
absolute maximum rating conditions for extended periods may affect device reliability.
[size=16px] As the title says, I don't know much about hardware. I think the signal should not change when the serial port is converted to USB and then USB to serial port. If it changes, is there any ...
Like all microcontrollers, Stellaris has its popular side and its unique side. With so many sides, let's see which sides you like.Please post your favorite features.Click on the image to enlarge...
I'm working on a project recently, which requires me to use a program to modify the IP, SUBMASK, and GATEWAY addresses. I have made the program, but I encountered a problem. When I changed the static ...
Live Replay: Microchip Security Series 17 - Pre-configured Wi-Fi? MCUs accelerate time to market and simplify production : https://training.eeworld.com.cn/course/26653...
I want to use LM358 as a current sampling circuit for a BUCK circuit, and put the sampling resistor on the low side! Do I need the same direction input or the reverse direction input? ! ! ! Is there a...
I am using a Windows 10 computer. I have installed the KW41Z connection software, Segger J-Link V6.12 and KDS V3.2 according to the requirements of FRDM-KW41Z. I can debug the FRDM-KW41Z application n...
Embedded System
京公网安备 11010802033920号
EEWORLD
