Figures 1 and 2 are photographs of digitized waveforms showing the typical clamping action of a 16A module. A 12 Ohm resistor is used to repre-
sent a 10A equipment load. The load is then subjected to the ANSI/IEEE C62.41 Catagory CI test conditions (6000V/3000A). These photographes
contrast the effect on equipment with and without the protector.
05016.R6 3/11
Page 1
www.protekdevices.com
05016
Only One Name Means ProTek’Tion™
587B051 - 587B301
tyPical Device chaRacteRistics
MaXiMuM Ratings
@ 25°c unless otherwise specified
PaRaMeteR
Operating Line Voltage: +10%
Line Current: 587B051/587B151/587B201/587B301
Peak Transient Voltage
Peak Transient Current
Current Leakage @ 130 Volts AC: Line-to-Neutral & Neutral-to-Ground
Operating Temperature - Note 1
Storage Temperature - Note 1
1. Measured at the center of the mounting surface.
syMBol
V
O
-
-
-
-
T
A
T
STG
value
130
5/15/20/30
6000
3000
1 & 0.5
-40 to 85
-40 to 85
units
Volts AC
Amps
Volts
Amps
mA
°C
°C
notes
electRical chaRacteRistics
@ 25°c unless otherwise specified
PRotection
MoDe
(note 1)
MaXiMuM
claMPing voltage
(note 2)
volts
Line to Neutral
Line to Neutral
Neutral to Ground
Neutral to Ground
notes
295
350
500
650
oPen ciRcuit
voltage
(note 2)
@1.2/50µs
volts
1000
6000
1000
6000
shoRt ciRcuit
cuRRent
(note 2)
@ 8/20µs
aMPs
500
3000
500
3000
1. Differential Mode Protection: Line to Neutral. Common Mode Protection: Neutral to Ground.
2. Test condition responses to transient voltages.
FilteR chaRacteRistics
(noise attenuation db)
Frequency (MHz)
Common Mode Attenuation
Differential Mode Attenuation
0.15
10
30
0.5
25
55
1.0
35
55
5.0
55
55
10
50
50
30
40
45
05016.R6 3/11
Page 2
www.protekdevices.com
05016
Only One Name Means ProTek’Tion™
587B051 - 587B301
tyPical Device chaRacteRistics
aRRestoR DeFinitions
Clamping Voltage: The clamping voltage of an arrester is the voltage that appears across its terminals during conduction of a transient current.
Standard Wave Form: The waveform of a surge current or voltage is designated by a combination of two numbers. The first number is for the time of the wave front
expressed in microseconds from zero to the peak of the wave. The second number is for the time of the wavetail also expressed in microseconds from zero to the
instant that the wavetail reaches one half of the crest or peak value, i.e., 8/20 µs waveform.
Transient Current: The transient current of an arrestor is the peak surge current which flows through the arrester when voltage clamping occurs.
oPeRation
For maximum effectiveness, the protector should be installed directly after the AC line on/off switch and fuse. This will protect the electronics from the AC line switch
arcing and the severe transients caused by a fuse clearing.
Some heat is produced when operating at full current load, and heat sinking may be required to maintain case temperature below 85°C. The case temperature is
measured at the center of the mounting surface. The unit should not be mounted to a low combusting temperature material such as wood.
High energy transients will cause a large circulating current in the AC input line (2,500A is possible). To prevent electromagnetic coupling, the AC line on the input side
of the protector must be dressed away from other wiring, magnetic shielding may be required. In addition, the electrical service must be connected to a low imped-
ance earth ground.
05016.R6 3/11
Page 3
www.protekdevices.com
05016
Only One Name Means ProTek’Tion™
587B051 - 587B301
PacKage inFoRMation
outline DiMensions
P/n
587B051
587B151
587B201
587B301
weight
250
500
750
850
inches
a
2.00
3.00
3.00
3.00
MilliMeteRs
e
1.50
1.50
1.50
1.50
B
2.00
2.00
3.00
3.00
c
2.50
3.50
3.50
3.50
D
3.00
4.00
4.00
4.00
F
0.60
0.60
0.60
0.60
g
0.169
0.169
0.169
0.169
a
50.8
76.2
76.2
76.2
B
50.8
50.8
76.2
76.2
c
63.5
89.0
89.0
89.0
D
76.2
102.0
102.0
102.0
e
38.2
38.2
38.2
38.2
F
15.2
15.2
15.2
15.2
g
4.29
4.29
4.29
4.29
D
C
F
E
LINE IN
LINE OUT
DEVICE
MARKING
NEUTRAL
GROUND
B
G
A
oRDeRing inFoRMation
Base PaRt nuMBeR
(xx = voltage)
587Bxxx
MaRKing
Part Number, Date Code, Voltage, Logo, Current Rating, CSA Logo
05016.R6 3/11
Page 4
www.protekdevices.com
05016
Only One Name Means ProTek’Tion™
587B051 - 587B301
coMPany inFoRMation
coMPany PRoFile
ProTek Devices, based in Tempe, Arizona USA, is a manufacturer of Transient Voltage Suppression (TVS) products designed specifically for
the protection of electronic systems from the effects of lightning, Electrostatic Discharge (ESD), Nuclear Electromagnetic Pulse (NEMP), in-
ductive switching and EMI/RFI. With over 25 years of engineering and manufacturing experience, ProTek designs TVS devices that provide
application specific protection solutions for all electronic equipment/systems.
ProTek Devices Analog Products Division, also manufactures analog interface, control, RF and power management products.
SPECIFICATIONS: ProTek reserves the right to change the electrical and or mechanical characteristics described herein without notice.
DESIGN CHANGES: ProTek reserves the right to discontinue product lines without notice and that the final judgement concerning selection and specifications is the buyer’s and that in furnishing engineering
and technical assistance. ProTek assumes no responsibility with respect to the selection or specifications of such products. ProTek makes no warranty, representation or guarantee regarding the suitability of
its products for any particular purpose, nor does ProTek assume any liability arising out of the application or use of any product or circuit and specifically disclaims any and all liability without limitation special,
consequential or incidental damages.
LIFE SUPPORT POLICY: ProTek Devices products are not authorized for use in life support systems without written consent from the factory.
PATENT INFORMATION: This device is patented under U.S. Patent No. 4,563,720
After I installed EVC4.0 and SP4, I found an error after compiling a program: Couldn't find include file "pkfuncs.h" file. How can I solve this problem? ? ? Thank you....
I have a BCM wireless router modem. On the wireless configuration page, the wireless authentication options are: Open, Shared, 802.1X, WPA, WPA-PSK, WPA2, WPA2-PSK, MixedWPA2/WPA, MixedWPA2/WPA-PSK. W...
CCS comes with a serial debugging port. Software used: Code Composer Studio Version: 6.1.0.00104 Simple serial port transmission and reception, receiving target board serial port information during de...
[i=s]This post was last edited by Yanda5zi on 2022-5-20 15:02[/i]I have received the BK7231N development board. The whole board is quite delicate and compact, with IC in the middle and pins on both si...
Mature Samsung S3C2440 solution and S3C2416 solution, WINCE5.0, NBOOT EBOOT, support SD card upgrade NK, upgrade NK under WINCE, boot customization and driver customization development and hardware cu...
The core of a machine vision system is image acquisition and processing. All information comes from images, and image quality is crucial to the entire vision system. A good image can improve the st...[Details]
Dual-mode inverters can operate both in conjunction with the grid and independently. These inverters can inject excess energy from renewable energy and storage devices into the grid, and withdraw p...[Details]
A vacuum eutectic furnace is a critical piece of equipment used in the manufacturing and processing of various materials, particularly in the fields of microelectronics and nanotechnology. One of t...[Details]
Long ago, the lifespan of cars in my country was 15 years. Once a car reached 15 years old, it was forced to be scrapped. However, the policy was later changed. As long as the car does not exceed 6...[Details]
summary
There are multiple approaches to making industrial systems more intelligent, including applying artificial intelligence (AI) technology at the edge and in the cloud to sensor...[Details]
Common Mode Semiconductor has officially released its latest generation of power management ICs—the GM6506 series. This fully integrated high-frequency synchronous rectification step-down p...[Details]
Since the beginning of this year, price wars have intensified, new models have been launched one after another, used cars with zero kilometers have become a hot topic, and the industry's internal c...[Details]
According to foreign media reports, Nissan Motor has recently reached a cooperation with US battery technology company LiCAP Technologies to jointly promote the research and development of next-gen...[Details]
introduction
According to the China Fire Statistics Yearbook, electrical fires accounted for more than 30% of fire accidents in the past decade, and the trend is increasing year by year. They ...[Details]
While the current industry consensus is that autonomous vehicles are robots and that their systems are managed using robotics-developed thinking, there are also cases where autonomous driving is ac...[Details]
With the rapid development of electric vehicles in my country, people are beginning to pay attention to the issue of radiation from electric vehicles. We all know that mobile phones emit radiation,...[Details]
1. Fault phenomenon and cause analysis
1. During the operation of the equipment, the expansion sleeve is subjected to a large torque, and the mating surfaces of the shaft and the sleeve move...[Details]
Chinese characters are extensive and profound, and there are many different names for ESD tubes. How many of them do you know?
As far as I know, ESD diodes are currently known as ESD p...[Details]
Preface
Low-voltage motors are widely used in nonferrous metallurgical plants. Their abnormal operation not only impacts normal production but can also threaten human life. Therefore, providin...[Details]
In the field of communications power supplies, AC/DC rectifier power supplies are called primary power supplies or basic power supplies, while DC/DC converters are called secondary power supplies. ...[Details]
Embedded System
京公网安备 11010802033920号
EEWORLD
