SL3-039-S172/01-88

For 80,000 ZTE (000063.SZ) employees and more Chinese ICT (information and communication technology) industry practitioners, the news from across the ocean on the evening of April 16 kept t...[Details]

In the actual project development process, we often need to get the running time of a section of code. The usual method is to use an oscilloscope to measure it. This blog post will use SysTick to acc...[Details]

0. Preparation First use st-link to connect the stm32 core board and PC for burning St-link Stm32 3.3V 3.3V GND GND SWDIO PART SWCLK DCLK Then connect with USB serial port board to v...[Details]

Regarding the PHY construction of LWIP, the PHY chip used is LAN8720A, RMII mode.  Regarding the hardware connection part, the Atomic board F407 is used, and the hardware connection is as follows:  ...[Details]

I used STM32CubeMX V4.22.1 to generate a project including EHT and Lwip. The debugging has been abnormal. After careful inspection, the following problems were found: 1. The hardware uses LAN8720A, b...[Details]

Timing and protocol are two key points in digital system debugging, and they are also where logic analyzers can play their most valuable role. How can we use a logic analyzer to quickly complete wiri...[Details]

OSC_IN and OSC_OUT are external crystal pins by default. If you do not use an external crystal oscillator on the STM32, how to connect OSC_IN and OSC_OUT If you use the internal RC oscillator instead...[Details]

/* Unfortunately, it cannot generate a standard 38kHz frequency square wave, there is a little error*/  #include reg51.h #define uchar unsigned char #define uint unsigned int  sbit Waveout=P1^0; //P...[Details]

The key is the configuration of registers. The T1 timer (16 bits) of CC2530 needs to configure three registers: T1CTL, T1STAT, IRCON Here is just a brief introduction. For more details, please refer ...[Details]

T1 or T2 are two timers/counters of MCS-51 microcontroller. The first method can use two timers/counters to generate rectangular waves. In order to save interface resources, the second method is used...[Details]

As shown in the figure, the circuit is required to count and display the number of times the button is pressed. When the button is pressed once, the count value increases by 1 (it is required to accu...[Details]

MCS-51 single-chip microcomputer timer/counter experiment programming program Programming requirements: 1. Connect a light-emitting diode LED to the P1.0 pin, light up for two seconds, turn off for o...[Details]

#include iom16v.h   #include macros.h #include "key.h" #include "1602.h" #include "delay.h" unsigned char display ={0,0,0}; //display data void main(void) {  unsigned char Key;    LCD_init();  ...[Details]

　　 Samsung has officially released its mobile phone chips. Meizu's recently released Meizu S6 uses Samsung 's Exynos7872 chip. Foreign media reports indicate that Samsung is trying to use its industr...[Details]

At the annual Semiconductor Strategy Symposium (ISS), semiconductor industry executives discuss semiconductor technology trends and global market developments. This article introduces the content a...[Details]