SPM10WLS-7

In the war without gunpowder between China and the United States, ZTE has become a new victim. The seven-year chip ban by the United States has pushed this communications giant to a life-or...[Details]

For STM32, there are two ways to reset the software:   1) Use the official software library     The system reset function is directly provided in the stm32f10x_nvic.c file of the official software li...[Details]

1. Development Environment       1. Applicable chips: All STM32F4 chips       2. Firmware library: STM32F4xx_DSP_StdPeriph_Lib_V1.8.0       3，IDE：MDK517 2. Driver source code       Delay.h...[Details]

Function List and Notes (lower-level driver part) 1. IO port initialization: control IO and communication IO. Control includes power control, reset and low power mode. Communication is the serial po...[Details]

China Energy Storage Network News: The State Grid Corporation of China, this elephant, is planning to turn around and enter the emerging power service market. The rallying cry for the tr...[Details]

Different from 51, AVR and other single-chip microcomputers, the clock signal sources of msp430 include LFXT1, XT2 and DCO. 1. LFXT1: It can connect high-speed and low-speed crystal oscillators. In l...[Details]

    This paper combines embedded control technology with network control technology to realize the design of temperature control system based on single chip microcomputer through Internet control. Th...[Details]

The analog watchdog of the ADC is used to check if the voltage is out of bounds. It has two upper and lower bounds, which can be set in the registers ADC_HTR and ADC_LTR respectively. The library fun...[Details]

LiDAR: Autonomous driving from the perspective of optoelectronic technology LiDAR and competing sensor technologies (camera, radar, and ultrasonic) intensify the need for sensor fusion and the need...[Details]

ADI has established long-term good relationships with car manufacturers and Tier 1 component suppliers. Based on its previous long-term successful cooperation with new energy vehicles and suppliers a...[Details]

The clock system of STM32 can be directly summarized in a diagram (from the STM32F10X reference manual).  The following is an analysis of this diagram 1. STM32 input clock source 1.1 Function of cl...[Details]

This program sets the LED running light and the 0-16 numbers of the 0th position of the digital tube to light up in a cycle. The digital tube program cannot be put into the main function, because the...[Details]

/*----------------------------------------------------------------------                             TMOD (89H)                     T1 T0       GATE C/T` M1 M0 GATE C/T` M1 M0 -----------------------...[Details]

;Question: The 80C51 single-chip microcomputer has a fosc = 6MHz. It is required to use the T1 timer working mode 1 to perform a timing of 40ms. And P1.7 periodically outputs a rectangular wave with ...[Details]

Requirements: Set timer T1 as an external event counter, count 500 pulses every time, then switch T1 to timing mode and output a positive pulse with a width of 10ms at P1.2. Over and over again. A...[Details]