Vectron International • 267 Lowell Road, Suite 102, Hudson, NH 03051 • Tel: 1-88-VECTRON-1 • http://www.vectron.com
Performance Specifications
Supply Voltage (Vs)
Parameter
Supply voltage (standard)
Current consumption
Load R
|| C
Output Power
Load
Signal Level (Vol)
Signal Level (Voh)
Rise and Fall time
Duty Cycle
Tuning Range
Tuning Range
Linearity
Tuning Slope
Control Voltage Range
Freq. control input impedance
0.3
10
1.65
±5.0
40
50
3.0
5
60
9
9
0.7
10
10
Min
3.135
Typical
3.3
Max
3.465
6
11
11
Units
VDC
mA
kΩ
pF
V
PP
Condition
2
steady state @ +25°C
RF Output (Clipped Sinewave)
@ 10kΩ || 10pF
RF Output (HCMOS)
13.5
15
16.5
0.3
pF
VDC
VDC
ns
%
@ (Voh-Vol)/2
Opti-
on
5
with Vs=3.3V
10 Hz
100 Hz
1k Hz
10 kHz
100 kHz
@ 10MHz
MIL-STD-202 Meth 213 Cond. F
JESD22-B104-B
MIL-STD-202G, Meth 214A, Cond II-K
with Vs=3.3V and 15pF Load
with Vs=3.3V and 15pF Load
Frequency Tuning (EFC)
Fixed TCXO; No adjust
±14.0
10%
Positive
3.0
VDC
kΩ
dBc/Hz
dBc/Hz
dBc/Hz
dBc/Hz
dBc/Hz
1.0 g
1500g 0.5ms 6 shocks in each axis
200g 1.5ms 6 shocks in each axis
53.79grms 15min per axis
Handling & Processing Note
±20.0
ppm
Additional Parameters
-95
-120
-143
-155
-157
Phase Noise
3
Weight
Mechanical Shock (TX-704 only)
Mechanical Shock (TX-703 only)
Random Vibration (TX-704 only)
Processing & Packing
Supply voltage (Vs)
Control Voltage
Operable Temperature Range
Storage Temperature Range
0
-40
-55
Absolute Maximum Ratings
6.0
Vs
+85
+125
V
V
°C
°C
s
ros
C
t
Lis
Standard Shipping Method
ce
ren
e
Ref
Enclosure Type
G290/G298
Tape Width W (mm)
12
Quantity per meter
150.
Page 2
Quantity per reel
750.
Dimension P
8
Vectron International • 267 Lowell Road, Suite 102, Hudson, NH 03051 • Tel: 1-88-VECTRON-1 • http://www.vectron.com
Type
G298
Standard Shipping Method
t
Lis
Package Codes: 703
e
c
ren
“H”
e
Type
Ref
Height
s
s
1.8mm
G290
Cro
Package Codes: 704
Height “H”
1.8mm
Pin Connections: TX-703
1
2
3
4
Voltage Control (Vc) / Enable / N.C
Ground (GND)
RF Output
Supply Voltage Input (Vs)
1
2
3
4
5
6
7
8
9
10
Pin Connections: TX-704
I.C. (Internal connected: do not connect)
N.C. (Not connected)
I.C. (Internal connected: do not connect)
Ground (GND)
RF Output
N.C. (Not connected)
N.C. (Not connected)
Enable / N.C.
Supply Voltage Input (Vs)
Voltage Control (Vc) / N.C.
Enable true table (optional): TX-703
Pin 1
High
Open
Low
Pin 3
Data
Data
High Tristate
Enable true table (optional): TX-704
Pin 8
High
Open
Low
Pin 5
Data
Data
High Tristate
Marking
TX-70X
Frequency
AYYWW
Page 3
Vectron International • 267 Lowell Road, Suite 102, Hudson, NH 03051 • Tel: 1-88-VECTRON-1 • http://www.vectron.com
Typical Measurement Data
Phase Noise
3
TX703 @ 10 MHz
MTIE according-1244-CORE:
TX-703 @ 10 MHz
Recommended Reflow Profile
Profile Feature
Average ramp-up rate (T
L
to T
P
)
Preheat
-Temperature Min T
Smin
-Temperature Min T
Smax
-Time (min to max) t
S
Pb-Free Assembly/
Sn-Pb Assembly
3°C/second max.
150°C
200°C
60-180 seconds
3°C/second max
217°C
60-150 seconds
max 260°C
Profile Feature
Time 25°C to Peak Temperature
Time maintained above
-Temperature (T
L
)
-Time (t
L
)
Pb-Free Assembly/
Sn-Pb Assembly
8 minutes max.
217°C
60-150 seconds
TSmax to TL -Ramp-up Rate
Time maintained above
-Temperature (T
L
)
-Time (t
L
)
Peak Temperature (T
P
)
Time within 5°C of actual Peak
Temperature (t
P
)
Ramp-down Rate
20-40 seconds
6°C/ second max
Note:
All temperatures refer to topside of the package, measured on the package body surface.
Page 4
Vectron International • 267 Lowell Road, Suite 102, Hudson, NH 03051 • Tel: 1-88-VECTRON-1 • http://www.vectron.com
Ordering Information
1, 5
TX-70X 0 - E A J - 287 0 - 10M0000000
Model Code
703: Enclosure G298
704: Enclosure G290
Height
0: 1.8mm
Frequency
Frequency Control
0: No Tuning
1: EFC: ±5.0 to 20ppm
2: Enable
3: Enable & EFC: ±5.0 to ±20ppm (only avail-
able for TX-704, 10-pin verion)
Supply Voltage
E: 3.3V
RF Output Code
A: HCMOS
F: Clipped Sinewave
Temperature Range & Stability Code
E-287: -40°C to +85°C, ±0.28ppm
J-287: -20°C to +70°C, ±0.28ppm
P-147: 0°C to +50°C, ±0.14ppm
Notes:
1. Contact factory for improved stabilities or additional product options. Not all options and codes are available at all
frequencies.
2. Unless other stated all values are valid after warm-up time and refer to typical conditions for supply voltage, frequency
control voltage, load, temperature (25°C).
3. Phase noise degrades with increasing output frequency.
4. Subject to technical modification.
5. Contact factory for availability.
For Additional Information, Please Contact
Microsemi
267 Lowell Road, Suite 102
Hudson, NH 03051
Tel: 1.888.328.7661
Fax: 1.888.329.8328
USA:
Vectron International GmbH
Landstrasse, D-74924
Neckarbischofsheim, Germany
Tel: +49 (0) 7268.801.100
Fax: +49 (0) 7268.801.281
Europe:
Microsemi
68 Yin Cheng Road(C), 22nd Floor
One LuJiaZui
Pudong, Shanghai 200120, China
Tel: +86 21 6194 6886
Fax: +86 21 6194 6699
Asia:
Disclaimer
Microsemi reserves the right to make changes to the product(s) and or information contained herein without notice. No liability is assumed as a result of their use or application. No rights
under any patent accompany the sale of any such product(s) or information.
Rev: 01/2018
Page 5
Vectron International • 267 Lowell Road, Suite 102, Hudson, NH 03051 • Tel: 1-88-VECTRON-1 • http://www.vectron.com
Recently, we have organized the information in the forum competition section, hoping to make it easier for everyone to browse! If you have better information during the preparation process, you can sh...
Power Supply Design Seminar: Multi-Phase Synchronous Boost Converter (2) : https://training.eeworld.com.cn/course/2189
Recent application requirements have shown a trend towards higher power requireme...
[i=s]This post was last edited by wudianjun2001 on 2018-9-2 17:44[/i] [align=left] I received the board today and opened it. It is quite good. This is my first time to use GD32 chip. It is very good t...
Hardware designers have begun to adopt FPGA technology in high-performance DSP designs because it can provide 10-100 times faster computing than PC-based or microcontroller-based solutions. Previou...[Details]
A single-chip microcomputer is also called a single-chip microcontroller. It is not a chip that completes a certain logical function, but a computer system integrated into one chip. In general, a c...[Details]
With the rapid development of science and technology, especially the widespread application of digital technology and various ultra-large-scale integrated circuits, electronic equipment, especially...[Details]
In
circuit design,
current
measurement
is widely used, and the main fields are divided into three categories: in measurement,
the electric meter
is used to measure the curre...[Details]
1. Introduction
Since the 1980s, with the continuous development of automotive electronic technology, there are more and more electronic control units in automobiles, such as electronic fuel i...[Details]
1 Introduction
As an emerging microfabrication technology, micro-electromechanical system (MEMS) technology has begun to be applied in various fields. It can integrate functions such as inform...[Details]
The data collector of the automatic weather station is generally designed based on a single-chip microcomputer or a PC/104 bus controller. It has the characteristics of good compatibility with PC, low...[Details]
1. Background:
The instrument system parameter detection and control of the chemical production workshop of Tangshan Coal Gas Coking Plant are all analog instruments, some of which are eve...[Details]
Flooded Batteries
This battery developed in Germany can be used to power flashlights, strobe lights and toys as long as it is filled with water. This battery can be stored for 50 years and can...[Details]
Introduction
Liquid crystal, as a display device, is widely used in low-power products such as instruments, meters, and electronic equipment with its unique advantages. In the past, the displ...[Details]
introduction
MAX6636 is a multi-channel precision temperature monitor that can not only monitor local temperature, but also connect up to 6 diodes externally. Each channel has a programmable...[Details]
The rectified DC voltage is then converted back to AC using power electronics such as insulated gate bipolar transistors.
The output voltage is switched on and off at a high frequency, control...[Details]
This article will introduce a design method for a distributed control system used in a tracking car, which can perform distributed control of motor modules, sensor modules, and lighting control mod...[Details]
The above is to use MB1404 as a stereo composite signal transmitter. You can use the internal high-frequency amplifier and oscillator or not! According to my experience, I still recommend beginners...[Details]
0 Introduction
There are many types of sensors, and the working principles, measurement targets and measurement environments of different types of sensors vary greatly. The corresponding detection s...[Details]
Download Centre
京公网安备 11010802033920号
EEWORLD
