NMC-H1812NPO330J500TRP

Dong Yang, executive vice president of the China Association of Automobile Manufacturers, said on the 26th that according to the authorization of the Ministry of Industry and Information Technology...[Details]

In recent years, as energy consumption and environmental protection issues have attracted people's attention, my country's solar photovoltaic power generation industry has shown a rapid development...[Details]

1. The first project We are going to create the first project, which is mainly for project analysis, so that we can understand how CubeMX works and how to trace the code logic. Okay, no more nonsense...[Details]

UART has three operation modes: polling mode, interrupt mode and DMA mode. Chip: STM32F103C8T6 Application Pin: Output: PA0, PA1 USART1 Configuration interface Add interrupt configuration Add DMA...[Details]

background After the hardware engineer completed the PCB and schematic design, the routine was modified according to the tutorial of Zhengdian Atom to verify the correctness of the hardware.  STM32F...[Details]

LAN8720 configuration:  IP: 192.168.192.30  Gateway: 192.168.192.1 A high frequency of ARP packets is detected The content of the packet asks for the mac address of 192.168.192.1, and asks the resp...[Details]

This small program is still the use of timer, which is relatively simple. The specific parts are noted in the comments, please refer to the comments. /*********************************************...[Details]

As photovoltaic power stations come into people's view, people are paying more and more attention to them. Recently, some netizens asked me how to match the inverter and components of photovoltaic ...[Details]

In order to strengthen the traceability management of recycling and utilization of power batteries for new energy vehicles, and to standardize and guide all relevant parties to fulfill their tracea...[Details]

    //Observe the difference between feeding the dog and not feeding the dog, and use the LED indicator of the PB port for status indication.     //Switch the LED indicator enable switch of the PB po...[Details]

At the beginning, I used the stdlib library. Recently, I found that the cube library is more and more widely used, so I started to use the cube library to complete the ADC multi-channel acquisition e...[Details]

The independent watchdog of STM32 is driven by a dedicated internal 40Khz low-speed clock, that is, it is still effective even if the main clock fails. Here we need to note that the clock of the inde...[Details]

1. A/D (Analog-to-Digital) and D/A (Digital-to-Analog) Conversion 1. Pin AOUT: Analog output Vref: reference voltage AGND: Analog ground EXT: Ground OSC: Floating SCL，SDA：IIC AIN0, AIN1, AIN2: anal...[Details]

Code: void TEST(volatile near unsigned char* IO,unsigned char n,BOOL value) { unsigned char  a; unsigned char  b; a=*IO; b=0x01; b=b n; if(value) { *IO=a | b; } else { b=~b; *IO=a & b; } } PIC stru...[Details]

#include avr/io.h void Delay(unsigned int T) { unsigned int i,j; for (i=0;i T;i++)   for (j=0;j 100;j++)    asmvolatile ("nop"); //Assembly instruction, let the microcontroller run empty instruction...[Details]