HL72151-2500-9H datasheet, PDF

HL72151-2500-9H: DescriptionBoard Connector; CategoryThe connector The connector; File Size264KB，2 Pages; ManufacturerFOXCONN; Websitehttp://www.fit-foxconn.com/

Download Datasheet Parametric View All

HL72151-2500-9H Overview

Board Connector

SPECIFICATIONS

1.ELECTRICAL CHARACTERISTICS:

1-1. CONTACT CURRENT RATING : 2 AMPERES PER CONTACT.

1-2. LOW LEVEL CONTACT RESISTANCE : 30 MILLIOHMS MAX.

INITIALLY;

40 MILLIOHMS MAX. AFTER LIFE TESTING.

1-3. INSULATION RESISTANCE: 1000 MEGOHMS MIN. .

1-4. DIELECTRIC WITHSTANDING VOLTAGE: 500VAC FOR 1 MINUTE.

Header Connector

HL72 Series

T/ H,PIN SOCKET

2.00mm Pitch

2.MECHANICAL CHARACTERISTICS:

2-1. CONTACT RETENTION FORCE: 1.36 Kgf MIN. PER CONTACT.

2-2. INSERTION FORCE: 0.40Kgf MAX. PER. PIN WITHDRAWL FORCE:

0.020Kgf MIN. PER. PIN

2-3. DURABILITY: 50 CYCLES

ENVIRONMENTAL DATA:

3-1. SOLDERABILITY: PASSED EIA-364-52.

3-2. OPERATION TEMPERATURE: -55℃ TO +105℃.

3-3. HARMFUL MATERIAL CONTROL PLEASE FOLLOW FOXCONN'S

DOC. "EPI12".

DRAWING

All specification & dimensions are subject to change, please call your nearest Foxconn sales representative for update information.

I just bought lm4f120, and when I adjust the PWM wave, I always run into a strange place.: The development environment is keil realview mdk, the source code is attached. There are two main problems: 1. When configuring GPIO, use the GPIOPinConfigure function, but GPIO_PXX_M0PWM0 is not foun...; 火书 Microcontroller MCU

I have a circuit design question: Why does the signal have to pass through the NAND gate before reaching the destination (AND with the high level, equivalent to no change); is there any harm in passing it directly?...; yangxf1217 PCB Design

Does STM32 need CPU participation to write SPIflah?: Does STM32 need CPU to be involved continuously when writing SPI flash? I mean, can the CPU do other work when writing SPI FLASH, such as ADC.In fact, this is the main summary of my other question." A...; eddie7434 stm32/stm8

The mouse cursor is not displayed when there is no mouse in the XPE C# software: The program running under xpe needs to realize the function of no mouse and no keyboard. It runs normally when the mouse is plugged in. After unplugging the mouse, the mouse cursor on the screen disap...; zhushuping Embedded System

The boiler pressure feed water pump is controlled by variable frequency PID, and the pressure always runs at or below the given pressure?: 1. The equipment is a constant pressure PID control system for the water supply pump in the hot water heating boiler room; 2. During debugging, it was found that the system pressure was controlled at ...; eeleader-mcu Industrial Control Electronics

Differences between software simulation and reality: void main(void) { int t; Init_CLK(); uint ch[8] = {0x01,0x02,0x04,0x08,0x10,0x20,0x40,0x80}; Init_Port(); t=KeyScan(); P5DIR=0XFF; P5OUT=ch[t]; while(1); } After using while, the output of P5 is corre...; wangfei890912 Microcontroller MCU

Popular Components