[font=微软雅黑][size=5]This article is transferred from Microchip Wheatfield Forum[/size][/font] 1. Introduction: The Harmony framework is shown in the figure below. In the system service, Harmony provide...
When debugging the USART of STM32F103,after initialization of USART1, the data is sent normally in a while (1) loop. After changing the initialization configuration of USART1 to USART2, including the ...
Use CS2, the bit width is 8bit, the addresses of the 4 digital tubes are: 0, 1, 2, 3 CS is configured to GPCM mode. What does it mean to use cs2 when making a digital tube driver for an mpc8313 develo...
I just came into contact with single-chip microcomputers and digital tubes. My four-bit common anode digital tube driver circuit is shown in the figure. It uses a triode [img]data:image/png;base64,iVB...
I recently wanted to use uc3842 to make a step-down circuit that can achieve 24V--5V. I will not consider the specific ripple requirements, power consumption, and efficiency. I have consulted some inf...
introduction
Since the beginning of the 21st century, the world of information has changed rapidly. Maybe a high-tech product will be released today and a better similar product will be releas...[Details]
At present, the traffic congestion in cities is quite serious. According to relevant news reports: In China, the traffic congestion has expanded from megacities such as Beijing, Shanghai, and Guang...[Details]
The Mobile Industry Processor Interface (MIPI) Alliance is an organization responsible for promoting the standardization of software and hardware in mobile devices. It has released the D-PHY specif...[Details]
In recent years, lighting has become an important area that countries around the world are targeting to promote energy conservation and environmental protection. According to statistics, about 20% ...[Details]
1 Introduction
Ultrasonic waves have strong directivity, slow energy consumption, and can propagate over long distances in a medium, so they are used for distance measurement. Ultrasonic detec...[Details]
introduction
MEMS is a high-tech that has flourished on the basis of integrated circuit production technology and dedicated micro-electromechanical processing methods. Pressure sensors develop...[Details]
Abstract: The output of high-range acceleration sensor is less than 10 mV under the excitation of small signal. The noise of traditional test system may cover such small voltage signal, so that hig...[Details]
introduction
LEDs continue to gain popularity in automotive applications, thanks to their long lifespan and the flexibility they offer for body styling and interior design. Some may be surpris...[Details]
1 Introduction to LED
With the development of science and technology, people have higher and higher requirements on automobile light sources. LED (Light Emitting Diode) has gradually attracted...[Details]
introduction
The core features of mobile value-added service products are mobility, immediacy and personalization. Mobile value-added services are a new service mode that is rapidly developing...[Details]
In the TV monitoring system, in order to complete the collection of information from various information points (video, audio, alarm signal) and the control of various front-end devices (PTZ, lens,...[Details]
Traditionally, when using PLC to control stepper motors, a dedicated stepper motor control intelligent module is usually added to the PLC, and then connected to the drive power supply to realize th...[Details]
In the test of the electronic ignition module, in order to simulate the real working conditions of the electronic ignition system, the electronic ignition module is often placed in an environment h...[Details]
As a type of iron battery, lithium iron phosphate battery (hereinafter referred to as lithium iron battery) has always been widely concerned by industry friends (some people say that lithium iron b...[Details]
Microchip MCU
京公网安备 11010802033920号
EEWORLD
