How can I share WINCE IST data with applications? I used to use deviceiocontrol, which was ok. But now my SPI driver reads data through interrupts. The application wants to get this data. How can I gi...
Supports AC and DC input, output +24V, +5V (2 independent channels), +15V, -15V, high efficiency, advanced technology, high quality output voltage, stable and reliable, with protection measures and po...
1. Key points of timer/counter PWM design According to the characteristics of PWM, the following points should be noted when using the ATmega128 timer/counter to design output PWM: 1. First, the PWM f...
Abstract : This paper introduces several operation modes of computer parallel port, and gives several schemes for realizing EPP interface design; it focuses on the implementation of EPP interface desi...
ESR's article also said that hackers have some special hobbies, and they are often non-rational hobbies. Maybe they need to change their minds. A typical example is Stevens, who died in a glider accid...
Source: Single-Chip Microcomputer and Embedded System Application Author: Zou Jiupeng, Lin Yaoyao, Zhou Jian, Dalian University of Technology
IntroductionCyclic Redundancy Check (CRC) is the most comm...
Assume that data is read from 8-bit AD (if it is a higher-bit AD, the data type can be defined as int), the subroutine is get_ad();
1. Limited secondary filtering
/* A value can be adjust...[Details]
Floating-point digital signal processing has become a constant requirement for precision technology, often in applications requiring high accuracy in areas such as aviation, industrial machinery, a...[Details]
The Mobile Industry Processor Interface (MIPI) Alliance is an organization responsible for promoting the standardization of software and hardware in mobile devices. It has released the D-PHY specif...[Details]
In this article, the high-performance DSP developed by TI can be used as an effective confidentiality method if it is applied to PC encryption cards.
As an effective network security solution,...[Details]
1 Introduction
Solar street lights are mainly composed of four parts: solar photovoltaic cell components, batteries, charge and discharge controllers, and lighting fixtures. The bo...[Details]
Battery life is critical for portable applications. For applications such as smoke detectors, security devices, and thermostats, factory-installed batteries need to last for more than 10 years. The...[Details]
1 Introduction
Ultrasonic waves have strong directivity, slow energy consumption, and can propagate over long distances in a medium, so they are used for distance measurement. Ultrasonic detec...[Details]
Contact resistance
is the resistance to current flow through a closed pair of contacts. This type of measurement is performed on devices such as connectors,
relays
, and switches. The...[Details]
A standard cell
is an electrochemical
cell
used as a voltage reference standard in many electrical standards laboratories
. If properly maintained, standard cells are very stable. The ...[Details]
I. Introduction
Since RS232 has a short communication distance (only 15 meters according to EAT/TAI-232 standard), and can only perform point-to-point communication, it cannot directly f...[Details]
1 Introduction to HART Protocol
HART (Highway Addressable Remote Transducer), an open communication protocol for addressable remote sensor high-speed channels, was launched by Rosemen in the U...[Details]
Digital array radar (DAR) uses digital beam forming (DBF) in both receiving and transmitting modes to achieve flexible distribution and reception of RF signal power in the airspace, obtain excellent t...[Details]
Overview
In spectral measurement, photomultiplier tubes (PMT) and charge-coupled devices (CCD) are often used as photoelectric converters. PMT is used in slow-changing, high-precision spectral...[Details]
TC9012F is a universal CMOS large-scale integrated circuit for infrared remote control signal transmission, suitable for remote control of TV, VTR, laser player and other equipment. In the market, ...[Details]