Information contained herein is deemed to be reliable and accurate as of the issue date. EMCORE reserves the right to change the design or specifications at any time without notice.
OTS-1LD
DWDM Wideband Optical Link
DATASHEET | DECEMBER 2012
SATCOM
Performance Highlights
Parameter
Link
Frequency Range
50 Ohm
75 Ohm
Link Gain @ 1 dB Optical Loss
Noise Figure (TG at Max, 2150 MHz, 1 dBo Loss)
Input IP3 (TG Max, 2150 MHz, 1 dBo Loss)
Spur Free Dynamic Range (1 dBo Loss)
Air Temperature
TX
RF Input within SGC range
1
TX Gain (TG) at max, 1 GHz
2
TG Adjustment Range (reduction from max)
Non DWDM Wavelengths
DWDM Wavelengths (See Center Wavelength Table for
Specific Channel Center)
Input Return Loss
50 - 200 MHz
950 - 2150 MHz
50 MHz - 3000 MHz
LNB Voltage
Current
Optical Power
DC Power
LNB Off
RX
RF Output (Tx at peak, 1 dBmo into Rx)
RX Gain (RG), at max, 1 GHz
2
RG Adjustment Range (reduction from max)
Output IP3 (2150 MHz)
Output 1dB compression (2150 MHz)
Receiver Sensitivity
Output Return Loss
50 - 200 MHz
950 - 2150 MHz
50 MHz - 3000 MHz
DC Power
1. Wider RF inputs are acceptable, but will set the RF amp gain to its limit.
2. Link RF Gain
dB
= TG + RG – 2*FiberLoss
dBo
(assumes Rin = Rout)
3. dBmo & dBo indicate optical power & loss to minimize confusion with RF dBm & dB
Information contained herein is deemed to be reliable and accurate as of the issue date. EMCORE reserves the right to change the design or specifications at any time without notice.
Information contained herein is deemed to be reliable and accurate as of the issue date. EMCORE reserves the right to change the design or specifications at any time without notice.
OTS-1LD
DWDM Wideband Optical Link
DATASHEET | DECEMBER 2012
SATCOM
Laser Safety
This product meets the appropriate standard in Title 21 of the Code of Federal Regulations (CFR). FDA/CDRH Class 1M laser
product. This device has been classified with the FDA/CDRH under accession number 0220191. All Versions of this laser are Class
1M laser product, tested according to IEC 60825-1:2007 / EN 60825-1:2007
An additional warning for Class 1M laser products. For diverging beams, this warning shall state that viewing the laser output
with certain optical instruments (for example: eye loupes, magnifiers, and microscopes) within a distance of 100 mm may pose
an eye hazard. For collimated beams, this warning shall state that viewing the laser output with certain instruments designed
for use at a distance (for example: telescopes and binoculars) may pose an eye hazard.
Wavelength = 1.3/1.5 μm.
Maximum power = 30 mW.
*Caution - Use of controls or adjustments or performance of procedures other than those specified herein may result in hazardous radiation exposure.
*IEC is a registered trademark of the International Electrotechnical Commision.
Information contained herein is deemed to be reliable and accurate as of the issue date. EMCORE reserves the right to change the design or specifications at any time without notice.
京公网安备 11010802033920号
EEWORLD
