For pricing, delivery, and ordering information, please contact Maxim/Dallas Direct! at
1-888-629-4642, or visit Maxim’s website at www.maxim-ic.com.
CDMA IF VGAs and I/Q Demodulators
with VCO and Synthesizer
MAX2306/MAX2308/MAX2309
ABSOLUTE MAXIMUM RATINGS
V
CC
to GND ...........................................................-0.3V to +6.0V
SHDN
to GND.............................................-0.3V to (V
CC
+ 0.3V)
STBY, BUFEN,
MODE,
EN,
DATA,
CLK, DIVSEL ...........................................-0.3V to (V
CC
+ 0.3V)
VGC to GND...............-0.3V, the lesser of +4.2V or (V
CC
+ 0.3V)
AC Signals TANKH ±, TANKL ±,
REF, FM ±, CDMA ± .................................................1.0V peak
Digital Input Current
SHDN,
MODE, DIVSEL,
BUFEN,
DATA, CLK,
EN, STBY
.....................................±10mA
Continuous Power Dissipation (T
A
= +70°C)
28-Pin QFN (derate 28.5mW/°C above T
A
= +70°C)...........2W
Operating Temperature Range ...........................-40°C to +85°C
Junction Temperature ......................................................+150°C
Storage Temperature Range .............................-65°C to +160°C
Lead Temperature (soldering, 10s) .................................+300°C
Stresses beyond those listed under “Absolute Maximum Ratings” may cause permanent damage to the device. These are stress ratings only, and functional
operation of the device at these or any other conditions beyond those indicated in the operational sections of the specifications is not implied. Exposure to
absolute maximum rating conditions for extended periods may affect device reliability.
DC ELECTRICAL CHARACTERISTICS
(V
CC
= +2.7V to +3.6V, MODE = DIVSEL =
SHDN
=
STBY
=
BUFEN
= high, differential output load = 10kΩ, T
A
= -40°C to +85°C,
registers set to default power-up settings. Typical values are at V
[font=微软雅黑][size=3][b]About the 2013 National Undergraduate Electronic Design Competition:[/b] [url=https://bbs.eeworld.com.cn/thread-350353-1-1.html]>>Introduction to the training for the 2013 Electr...
In the lab, the mobile signal was between full and four bars. Since China Unicom built a signal transmitting device (not sure if it was a base station) on the rooftop less than 50 meters away, the mob...
After a simple installation, the appearance is similar to software visual. I checked the support list introduced in the introduction and found that the entire series of MSP430 are also supported. The ...
When debugging the ti routine, abnormal noise appears in the current closed loop. After switching into the speed loop, the abnormal noise still exists. Note: Under open loop (directly given VD, VQ), t...
[font=微软雅黑][size=3]Electric vehicles, fast charging, linear charging and other hot applications are all in the TI BMS battery management product topic! {:1_108:}[/size][/font] [font=微软雅黑][size=3]Innov...
[i=s]This post was last edited by qwqwqw2088 on 2016-5-14 22:11[/i] [align=left]Toyota has developed an intelligent three-wheeled electric vehicle, the i-Road. From the outside, the i-Road is small an...
introduction
1 The significance of using RTOS on MSP430
It is understandable that it is meaningless to use RTOS on MSP430. Because the hardware resources of MSP430 are limited (for exampl...[Details]
When the WDP500-2A plane grating monochromator is used to test the emission wavelength of a high-power laser diode at different currents, the matching of the laser diode has the disadvantages of lo...[Details]
1. Introduction
Since the 1980s, with the continuous development of automotive electronic technology, there are more and more electronic control units in automobiles, such as electronic fuel i...[Details]
There are three types of mobile TV: one is based on analog TV broadcasting network, another is based on mobile communication network, and the other is based on digital broadcasting network. The f...[Details]
introduction
For the voltage regulator modules (VRMs) that power the latest computer central processing units (CPUs), power supply designers have historically used multiphase interleaved b...[Details]
Aromatic gases are widely present in food, medicine, cosmetics and various daily chemical products, such as snacks, liquor, spices, Chinese herbal medicines, plasters, perfumes, soaps, shampoos, et...[Details]
Product series: PB-B-RS232/485 interface (hereinafter sometimes referred to as "interface") is a product in the PROFIBUS bus bridge series.
The main purpose of the bridge series ...[Details]
0 Introduction
With the rise and continuous improvement of the solid-state lighting industry, light-emitting diodes (LEDs) have become an alternative lighting technology and are gr...[Details]
Toyohashi University of Technology demonstrated electric field coupled wireless power supply technology using life-size car tires and roads at the wireless technology exhibition "Wireless Technolog...[Details]
1 Introduction
There have been many studies on the detection and protection of power grid short circuit and line fault. The short circuit, overload and overvoltage protectors on the market have ...[Details]
Single-chip microcomputers are widely used because of their small size, powerful functions and low price. This article introduces the method of designing a micro electronic piano using the AT89C51 sin...[Details]
1. When the slip speed regulating motor is undergoing frequency conversion and energy saving transformation, the original excitation box (referred to as the speed regulating box) and the original s...[Details]
Abstract: Aiming at the needs of coal-rock acoustic emission signal monitoring system, a data acquisition circuit with 24-bit resolution and 16-channel synchronous data acquisition function is desi...[Details]
Abstract: With the development and construction of BeiDou II system, China will shift from the situation dominated by GPS to the situation dominated by BeiDou II global navigation system independen...[Details]
Only a small number of LED manufacturers can produce high-quality LEDs. For applications that are only used for simple indication, low-quality LEDs are sufficient. However, high-quality LEDs must...[Details]