Hey guys, I use AT command to dial in HyperTerminal, the configuration is as follows: AT+CGCLASS="B" OK AT+CGDCONT=1,"IP","CMNET" OK AT+CGATT=1 OK AT+CGACT=1,1 OK AT+CGPADDR=1 +CGPADDR: 1,"010.206.227...
[i=s]This post was last edited by Shi Yu on 2017-4-1 14:15[/i] [b][color=#5E7384]This content was originally created by EEWORLD forum user [size=3]Shi Yu[/size]. If you need to reprint or use it for c...
[size=12px] Fresh graduates should not work on consumer electronics hardware. Because if you want to change careers in the future, people won’t give you a chance, and your salary won’t go up. If you l...
Abstract: The electromagnetic compatibility (EMC) design of monolithic switching power supply is introduced, including the analysis of electromagnetic interference waveform and circuit model, as well ...
The scalable hardware architecture of the DesignWare ARC EV6x embedded vision processor is used to optimize its algorithm migration and accelerate software. The architecture includes up to four 512-bi...
Abstract: The full digital phase-locked loop implemented in FPGA is very widely used. This paper improves the integrated digital phase-locked loop 74297, designs a phase-locked state detection circuit...
introduction
Since the beginning of the 21st century, the world of information has changed rapidly. Maybe a high-tech product will be released today and a better similar product will be releas...[Details]
1. Introduction
RFID (radio frequency identification) is a non-contact automatic identification technology that emerged in the 1990s. It uses the characteristics of radio frequency signal prop...[Details]
1. Introduction
This design was made for participating in an electronic design competition. It effectively solved the problem of the operation and control of an electric car on a seesaw. The s...[Details]
0. Introduction
In daily life, we often see some special-purpose vehicles. When these vehicles pass through intersections, they often obtain the right of way at intersections by temporarily op...[Details]
With the advent of increasingly powerful processors, image sensors, memory, and other semiconductor devices, as well as the algorithms that enable them, computer vision can be implemented in a wide...[Details]
In public places such as schools, government agencies, factories and mines, as well as public corridors in residential areas, the phenomenon of long-burning lights is very common, which causes a h...[Details]
Electronic systems are located at different points on the automotive power bus and therefore often need to operate under very stringent power requirements. These include load dump, cold crank, very lo...[Details]
The data collector of the automatic weather station is generally designed based on a single-chip microcomputer or a PC/104 bus controller. It has the characteristics of good compatibility with PC, low...[Details]
Product series: PB-B-RS232/485 interface (hereinafter sometimes referred to as "interface") is a product in the PROFIBUS bus bridge series.
The main purpose of the bridge series ...[Details]
1 Introduction
PROFIBUS is an international, open, and manufacturer-independent fieldbus standard. It is widely used in manufacturing automation, process industry automation, and automatio...[Details]
1. Introduction
Testing the temperature of steel billets before rolling is an important measure to ensure the quality of steel. Traditional manual testing is difficult to ensure product qu...[Details]
As people's requirements for safety and comfort in the process of driving cars continue to increase, automotive radars are widely used in the car's adaptive cruise system, collision avoidance syste...[Details]
Since the late 1990s, with the demand for higher system efficiency and lower power consumption, the technological update of telecommunications and data communication equipment has promoted the deve...[Details]
0 Introduction
Under normal circumstances, the three-phase power in the power system is symmetrical, and they meet certain amplitude and phase conditions; but when the load changes, the syst...[Details]
1. Proposal of
reconfigurable
measurement and control system
The measurement and control system generally refers to a system based on
computers
to realize data acquisition a...[Details]