Security & Chip Card ICs
SLE 44C42S
8-bit Security Controller with
17-Kbyte ROM, 256 byte RAM
4-Kbyte EEPROM and Sleep Mode
Short Product Information 07.99
SLE 44C42S Short Product Information
Revision History:
Previous Releases:
Page
Current Version 07.99
2.0 (06.98)
Subjects (changes since last revision)
Layout change
Important
:Further information is confidential and on request. Please contact:
Infineon Technologies AG in Munich, Germany,
Security & Chip Card ICs,
Fax +49 89 234-28925
Published by Infineon Technologies AG i.Gr., CC Applications Group
St.-Martin-Strasse, D-81541 München
© Infineon Technologies AG i.Gr. 1999
All Rights Reserved.
Attention please!
The information herein is given to describe certain components and shall not be considered as warranted
characteristics.
Terms of delivery and rights to technical change reserved.
We hereby disclaim any and all warranties, including but not limited to warranties of non-infringement, regarding
circuits, descriptions and charts stated herein.
Infineon Technologies is an approved CECC manufacturer.
Information
For further information on technology, delivery terms and conditions and prices please contact your nearest Infineon
Technologies Office in Germany or our Infineon Technologies Representatives world-wide (see address list).
Warnings
Due to technical requirements components may contain dangerous substances. For information on the types in
question please contact your nearest Infineon Technologies Office.
Infineon Technologies Components may only be used in life-support devices or systems with the express written
approval of Infineon Technologies, if a failure of such components can reasonably be expected to cause the failure of
that life-support device or system, or to affect the safety or effectiveness of that device or system. Life support devices
or systems are intended to be implanted in the human body, or to support and/or maintain and sustain and/or protect
human life. If they fail, it is reasonable to assume that the health of the user or other persons may be endangered.
SLE 44C42S
8-bit Security Controller with
17-Kbyte ROM, 256-byte RAM, 4-Kbyte EEPROM and Sleep Mode
Features
•
8-bit microcomputer in CMOS
technology
•
Instruction set opcode compatible with
standard SAB8051 processor
•
Software compatible with SLE 44C40
•
Dedicated, non-standard architecture
with execution time less than half of
standard SAB 8051 processor
•
15-Kbyte User ROM
for application
programs
•
2-Kbyte manufacturer ROM for
Chip
Management System
(CMS)
•
4-Kbyte EEPROM
as program/data
memory
•
256-byte RAM
•
Power saving sleep mode
•
Clock freq. = int. freq.:
1 to 5 MHz
1)
at 5 V
±
10 %,
1 to 4 MHz at 3 V
±
10 %
•
•
•
•
•
Contact configuration and serial
interface in accordance with ISO7816
Supply voltage range: 2.7 V to 5.5 V
< 10 mA supply current at 5 MHz
Temperature range: – 25 to + 70 °C
2)
ESD protection larger than 4 kV
EEPROM
•
Reading, erasing and writing byte by
byte
•
Flexible page mode for 1 to 16 bytes
write/erase operation
•
32 bytes security area
•
Write time 3.5 ms, erase time 1.75 ms
•
Frequency-adaptable programming
time
•
Minimum of 500,000 write/erase
cycles
3)
•
Data retention for minimum of ten years
•
EEPROM programming voltage
generated on chip
Security Features
•
ROM code not visible due to
implantation
•
Low voltage sensor
•
High voltage sensor
•
Low-frequency sensor
•
High-frequency protection
•
16 bytes security PROM, hardware
protected
•
Unique chip identification number for
each chip
CMS
•
Intelligent write/erase routines for N
bytes programming (0 < N < 256)
•
Two serial interface modes
according to ISO 7816-3:
– 9600 bit/s related to 3.57 MHz
– 9600 bit/s related to 4.91 MHz
1)
2)
3)
Extended frequency range up to 7.5 MHz is available, see ordering information.
Extended temperature range is available for certain applications, e.g. GSM, see ordering information.
Values are temperature dependent, for further information please refer to your Infineon Technologies
Sales Office.
Short Product Information
3/5
07.99
SLE 44C42S
Ordering Information
Type
SLE 44C42S-M4
SLE 44C42S -C
SLE 44C42S -T85-M4
SLE 44C42S -T85-C
SLE 44C42S -V5-M4
SLE 44C42S -V5-C
SLE 44C42S -V5-T85-M4
SLE 44C42S -V5-T85-C
SLE 44C42S -V5-F7-M4
SLE 44C42S -V5-F7-C
Package
1
Voltage Range Temperature
Range
M4
C
M4
C
M4
C
M4
C
M4
C
4.5 V - 5.5 V
– 25°C to + 70°C
1 MHz - 7.5 MHz
4.5 V - 5.5 V
– 25°C to + 85°C
1 MHz - 5 MHz
4.5 V - 5.5 V
– 25°C to + 70°C
1 MHz - 5 MHz
2.7 V - 5.5 V
– 25°C to + 85°C
1 MHz - 5 MHz @ 5V
1 MHz – 4 MHz @ 3V
2.7 V - 5.5 V
– 25°C to + 70°C
Frequency Range
1 MHz - 5 MHz @ 5V
1 MHz – 4 MHz @ 3V
Pin Description
Figure 1
Pin Configuration (top view)
1
available as wire-bonded module (M4) for embedding in plastic cards or as die (C) for customer packaging
Short Product Information
4/5
07.99
SLE 44C42S
Pin Definitions and Functions
Card Contact
C1
C2
C3
C5
C4;C6,C8
C7
Symbol
VCC
RST
CLK
GND
N.C.
I/O
Function
Operating voltage
Reset input
Processor clock input
Ground
Not connected
Bi-directional data port
General Description
SLE 44C42S is a member of the Infineon Technologies 44 security microcontroller family,
especially designed for smart card applications. The devices fabricated in an Infineon
Technologies proprietary CMOS technology, resulting in a significant reduction of die size
compared to the SLE 44C40. New features such as low voltage operation, extended page
mode and I/O routines offer additional performance required in applications like 3V SIM
cards for GSM, banking, health care, security access or loyalty, while maintaining software
compatibility to the SLE 44C40.
Short Product Information
5/5
07.99