SF63

A single-chip microcomputer is also called a single-chip microcontroller. It is not a chip that completes a certain logical function, but a computer system integrated into one chip. In general, a c...[Details]

introduction my country has a vast territory and a large population. The scale of housing construction is huge, and the amount of residential construction is large and wide. It is still on t...[Details]

1. Introduction Since the 1980s, with the continuous development of automotive electronic technology, there are more and more electronic control units in automobiles, such as electronic fuel i...[Details]

In this article, the high-performance DSP developed by TI can be used as an effective confidentiality method if it is applied to PC encryption cards. As an effective network security solution,...[Details]

In recent years, lighting has become an important area that countries around the world are targeting to promote energy conservation and environmental protection. According to statistics, about 20% ...[Details]

Battery life is critical for portable applications. For applications such as smoke detectors, security devices, and thermostats, factory-installed batteries need to last for more than 10 years. The...[Details]

Contact resistance is the resistance to current flow through a closed pair of contacts. This type of measurement is performed on devices such as connectors, relays , and switches. The...[Details]

1 Introduction to HART Protocol HART (Highway Addressable Remote Transducer), an open communication protocol for addressable remote sensor high-speed channels, was launched by Rosemen in the U...[Details]

Abstract: The output of high-range acceleration sensor is less than 10 mV under the excitation of small signal. The noise of traditional test system may cover such small voltage signal, so that hig...[Details]

Only a small number of LED manufacturers can produce high-quality LEDs. For applications that are only used for simple indication, low-quality LEDs are sufficient. However, high-quality LEDs must...[Details]

The rectified DC voltage is then converted back to AC using power electronics such as insulated gate bipolar transistors. The output voltage is switched on and off at a high frequency, control...[Details]

Introduction Nowadays, people pay more and more attention to the security alarm system, and people have higher and higher requirements for the functions and performance of the alarm. This paper prop...[Details]

1. Introduction With the increasing popularity of fully automatic washing machines, consumers have higher and higher requirements for their environmenta...[Details]

Introduction In industrial control, speed measurement is often required. Generally, a contact tachometer is used. This tachometer must be placed against the center of the shaft to measure. It...[Details]

0 Introduction Ultrasonic waves are mechanical waves with a frequency of more than 20KHz, and the propagation speed in the air is about 340 m/s (at 20°C). Ultrasonic waves can be gene...[Details]