EEWORLDEEWORLDEEWORLD

Part Number

Search

3GP576A-80T-212.500MHZ

Description
Oscillator,
CategoryPassive components    oscillator   
File Size262KB,1 Pages
ManufacturerEuroquartz
Websitehttp://www.euroquartz.co.uk/
Download Datasheet Parametric Compare View All

3GP576A-80T-212.500MHZ Overview

Oscillator,

3GP576A-80T-212.500MHZ Parametric

Parameter NameAttribute value
Objectid109815857
Reach Compliance Codecompliant

3GP576A-80T-212.500MHZ Preview

EURO
QUARTZ
Stable and clean 100KH differential signals
Uses Inverted MESA, fundamental-mode crystals
No PLL, multiplier or overtone-mode crystals used
Very low jitter <1ps
Miniature 6 pad package, RoHS Compliant
GP576 Series PECL VCXOs
7 x 5 x 2mm SMD Low Jitter PECL VCXO
·
DESCRIPTION
GP
series VCXOs use fundamental mode (inverted mesa) crystal to
achieve wide frequency deviation with stable and clean signals. No
multiplier, overtone crystal or phase lock loop technique is used. As a
result Jitter is as low as for instance 1ps for the 155.520 MHz for
SONET/SDH application. Additionally, the inherent advantages of
differential PECL ECL signal transmission provide improved noise
immunity making the system less susceptible to ground noise.
SPECIFICATION
Frequency Range:
Output Waveform:
Standard Frequencies:
OUTLINE & DIMENSIONS
Output Load:
Frequency Stability:
Input Voltage (Vcc)
LVPECL:
PECL:
Supply Voltage
Dependant Parameters
Initial Frequency Accuracy
To tune to nominal
frequency with:
Output Voltage HIGH ‘1’:
Output Voltage LOW ‘0’:
Rise/Fall Time
Current Consumption:
Duty Cycle:
Integrated Jitter RMS:
12kHz to 20MHz:
SSB Phase Noise
19.440MHz to 250MHz
PECL 100K square wave
38.880, 44.736, 50.0, 77.76,
100.0, 106.25, 125.0, 155.52,
166.6286, 200.0, 207.360 and
212.50MHz
(Partial List)
15pF
see table
+3.3 VDC ±5%
+5.0 VDC ±5%
Supply Voltage
+3.3 Volts ±5%
+5.0 Volts ±5%
Vc=+1.65V±0.2V
2.27V minimum
1.68V maximum
5ns maximum
Vc=+2.5V±0.2V
4.5V minimum
3.35V maximum
7ns maximum
FREQUENCY STABILITY
Stability Code Stability ±ppm Temp. Range
A
25
0°~+70°C
B
50
0°~+70°C
C
100
0°~+70°C
D
25
-40°~+85°C
E
50
-40°~+85°C
F
100
-40°~+85°C
If non-standard frequency stability is required
Use ‘I’ followed by stability, i.e. I20 for ±20ppm
PART NUMBERING
Example:
Supply Voltage
3 = +3.3V
5 = +5.0V
Series Designator
Stability over temperature range
(See table)
Pullability in ±ppm
Pullability determinator
N = minimum
M = maximum
T = Typical
Frequency in MHz
80mA max.
(Frequency dependant)
50%±2% typical, 50%±5% max.
0.4ps typical, 0.5ps max.
(Example at 155.250MHz)
10Hz offset:
100Hz offset:
1kHz offset:
10kHz offset:
100kHz offset:
1MHz offset:
-50dBc
-80dBc
-110dBc
-135dBc
-145dBc
-145dBc
Frequency Deviation Range
Supply = 3.3 V:
Supply = 5.0 V:
±80ppm
±100ppm
(Wider pull range available)
Linearity:
±10% max.
Slope Polarity:
Monotonic and Positive
(An increase of control voltage increases output freq.)
Start-up Time:
10ms max.
Input Impedance:
>10kOhm
3dB Modulation Bandwidth:
10Hz minimum
Ageing:
±2ppm year max at 25°C
Storage Temperature:
-55° to +100°C
Tristate function (Pad 2):
PECL output is disabled and Complimentary output
remains high when tristate pad is HIGH. Both outputs
are HIGH when Tristate pin is LOW.
3G576B-80N-27.000
EUROQUARTZ LIMITED Blacknell Lane CREWKERNE Somerset UK TA18 7HE
Tel: +44 (0)1460 230000 Fax: +44 (0)1460 230001 Email: info@euroquartz.co.uk www.euroquartz.co.uk

3GP576A-80T-212.500MHZ Related Products

3GP576A-80T-212.500MHZ 3GP576D-80T-125.000MHZ 3GP576D-80T-250.000MHZ 3GP576D-80T-38.880MHZ 5GP576C-100T-212.500MHZ 5GP576E-100T-212.500MHZ 5GP576F-100T-212.500MHZ 5GP576D-100T-125.000MHZ
Description Oscillator, Oscillator, Oscillator, Oscillator, Oscillator, Oscillator, Oscillator, Oscillator,
Reach Compliance Code compliant compliant compliant compliant compliant compliant compliant compliant
Objectid 109815857 - - - 109815969 109815997 109816011 109815978
What is a pull-up resistor and what is a pull-down resistor? What do they do?
A: The two Bias Resaitor resistors shown in the figure below are pull-up resistors and pull-down resistors. In the figure, the upper Bias Resaitor resistor is grounded, so it is called a pull-down res...
fighting Analog electronics
There is a problem with JLINK settings. What should I do?
I was able to simulate before. I was able to download the program. Later I set it upIt just doesn't work. It keeps saying AXD Uable to halt ARM core and I don't know what went wrong.Anyone who knows p...
谢谢分享 ARM Technology
I had nothing to do at home tonight, so I made an LED lighting lamp for my old refrigerator
Last summer, the light bulb of the old refrigerator that I had used for more than 20 years (bought by my parents, and it was not enough after I bought a new refrigerator, so I kept using it) broke, wh...
zhdphao Analog electronics
Help with Advanced Design System 2015.01 Getting Started Tutorial
Advanced Design System 2015.01 Tutorial...
Ethan(伊桑) PCB Design
Year-end summary --- my 2016
Time flies like an arrow. At this time of year, the company is doing the year-end summary. I just finished the company's year-end summary and then did the year-end summary of EEworld. I will summarize...
wuyh123 Talking
If you want to learn UC/OS II operating system, please look here. Here is the good information you need!
uC/OS II (Micro Control Operation System Two) is a scalable, preemptive, real-time multitasking kernel that can run on ROM. It is highly portable and is particularly suitable for microprocessors and c...
okhxyyo Real-time operating system RTOS

EEWorld
subscription
account

EEWorld
service
account

Automotive
development
circle

Robot
development
community

Index Files: 612  502  526  2808  1664  13  11  57  34  46 
Datasheet   0 1 2 3 4 5 6 7 8 9 A B C D E F G H I J K L M N O P Q R S T U V W X Y Z
Room 1530, 15th Floor, Building B, No. 18 Zhongguancun Street, Haidian District, Beijing Telephone: (010) 82350740 Postal Code: 100190
Copyright © 2005-2026 EEWORLD.com.cn, Inc. All rights reserved 京ICP证060456号 京ICP备10001474号-1 电信业务审批[2006]字第258号函 京公网安备 11010802033920号