For pricing, delivery, and ordering information, please contact Maxim/Dallas Direct! at
1-888-629-4642, or visit Maxim’s website at www.maxim-ic.com.
150Mbps Automotive Fiber Optic Receiver
MAX3901/MAX3902
ABSOLUTE MAXIMUM RATINGS
Supply Voltage (V
CC
) ...............................................-0.5V to +6V
Current into IN ....................................................................±3mA
Voltage at OUT+, OUT- (MAX3902) .............................0V to +6V
Current into OUT_TTL (MAX3901)....................................±10mA
Current into FILT ..................................................................-3mA
Voltage at STATUS .......................................-0.5V to (V
CC
+ 0.5)
Operating Junction Temperature Range ............-55°C to +150°C
Storage Temperature Range .............................-65°C to +175°C
Die Attach Temperature...................................................+400°C
Stresses beyond those listed under “Absolute Maximum Ratings” may cause permanent damage to the device. These are stress ratings only, and functional
operation of the device at these or any other conditions beyond those indicated in the operational sections of the specifications is not implied. Exposure to
absolute maximum rating conditions for extended periods may affect device reliability.
Currently, there is a board using TD1509-P5, the output current is about 30ma, the inductor is 47uh/1a, and the output capacitor is a 100uF high-frequency electrolytic capacitor. However, in actual op...
[p=28, 2, left][color=rgb(0, 0, 0)][font=微软雅黑,][color=#000][url=http://www.21ic.com/jichuzhishi/analog/]Op amp[/url][/color]The input offset voltage refers to the value of the voltage at the output te...
[size=2]Since the launch of the NXP LPC1100 Design Challenge, we have more than 500 Community Members and over 100 Contestants in the Challenge.The Design Challenge gives contestants an opportunity to...
The chip is MSP430F247, which has two serial port transceiver modules. When the serial port receiving interrupt is set at the same time, only the serial port 1 module responds to the interrupt, and th...
Ye Deng has a devious mind and is a bit of a psychopath. He rented out his extra house to a newly married young couple. Before they moved in, Ye Deng installed a pinhole camera in a hidden place, read...
UHF and HF are both general technology categories, but each category has independent supporting protocols. HF is more consistent in the 13.56MHz frequency band, although there are many internation...[Details]
The circuit shown in the figure is a three-digit tachometer used to measure low frequency signals with a repetitive time interval of 0.235 to 15 seconds. The tachometer has a speed range of 4 to 255 r...[Details]
Until now, designers have faced a trade-off in ADC selection. Pipeline converters offer high resolution and wide dynamic range, but their power consumption is quite high. The alternative, discrete ...[Details]
No other sector is feeling the pressure for change more acutely than the healthcare industry. Healthcare organizations and services are desperate to reduce costs, but the challenge is to do so without...[Details]
The hardware circuit principle is shown in Figure 1. In the specific design, each part should consider the anti-interference problem to minimize the impact of interference on the performance of the...[Details]
WiMax technology needs to demonstrate its advantages in specific application scenarios in order to gain market recognition, which requires application testing to measure system performance para...[Details]
Signal sources have developed to a very wide range today. We can classify them according to the frequency range: ultra-low frequency (0.1m～1kHz), audio (20Hz～20kHz), video (20kHz～10MHz), radio fre...[Details]
Preface
Phase-modulated pulse signals can achieve a large compression ratio. As a commonly used pulse compression signal, they are widely used in modern radar and communication systems. Wi...[Details]
Power Integrations (PI) has introduced three charger/adapter reference designs using its new LinkSwitch-II series of AC-DC switching power conversion ICs. The new LinkSwitch-II devices use high-pre...[Details]
1. What is fading?
In terms of scope, fading can be roughly divided into three types: large area fading, small area fading and indoor fading. As shown in Figure 1, large area fading refers t...[Details]
Abstract:
An amplifier solution for ceramic speaker systems is presented.
Keywords:
audio; ceramic speaker; amplifier; Class G
Today's portable devices require smaller, thinne...[Details]
Siimpel announced that its MEMS-based silicon camera technology, SiimpelFocus SF9x, has been used in Motorola's newly released MING A1600 mobile phone. The MING A1600 is the industry's first mobile...[Details]
FSK (Frequeney-Shift Keying) uses carriers of different frequencies to transmit digital signals. FSK signals have the advantages of strong anti-interference ability and long transmission distance, and...[Details]
1 Introduction
With the rapid development and continuous progress of computer, network communication and Internet technology, embedded systems are widely used in homes and industries. ...[Details]
The full name of RFID is Radio Frequency Identification, which uses radio frequency to realize data transmission between programmable controller (PLC) or microcomputer (PC) and identification, ther...[Details]
LED Zone
京公网安备 11010802033920号
EEWORLD
