EEWORLDEEWORLDEEWORLD

Part Number

Search

PH1-GLPLA2642

Description
Transponder, 10000Mbps(Tx), 10000Mbps(Rx), LC/SPC Connector,
CategoryWireless rf/communication    Optical fiber   
File Size240KB,6 Pages
ManufacturerLumentum Operations LLC
Download Datasheet Parametric View All

PH1-GLPLA2642 Overview

Transponder, 10000Mbps(Tx), 10000Mbps(Rx), LC/SPC Connector,

PH1-GLPLA2642 Parametric

Parameter NameAttribute value
Objectid4000952299
Reach Compliance Codecompliant
Other featuresIT ALSO OPERATE FROM 1280NM TO 1600NM
body width56.1 mm
body height13.2 mm
Body length or diameter76.5 mm
Connection TypeLC/SPC CONNECTOR
Data rate (receive)10000 Mbps
Data rate (send)10000 Mbps
Emitter/Detector TypePIN PHOTODIODE
Fiber optic equipment typesTRANSCEIVER, TRANSPONDER
Nominal operating wavelength1530 nm
Nominal optical power output1.584 mW
minimum return loss-27 dB
Sensitivity-17 dBm
COMMUNICATIONS MODULES & SUBSYSTEMS
10 Gb/s TDM/DWDM 300 Pin SFF MSA SR2/IR2/LR2 Transponder
PH1 Series
Key Features
• Three configurations supporting SR2/IR2/LR2 applications
• Supports dense wavelength division multiplexing
(DWDM) applications (without wavelocker)
• Microprocessor controls to support I2C
• Integrated 16:1/1:16 mux/demux
• Small form factor package (2.2" x 3.0" x 0.53") for high
density applications
• Low power consumption: 4.8 W typical, 6.8 W maximum
for TDM applications
• 70 °C maximum operating temperature
• High sensitivity PIN or APD receivers
• SONET, FEC, Ethernet and Multirate Capable Versions
• Forward, counter and line timing clocking modes
Applications
Telecommunications
Metropolitan Area Networks
Subscriber loop
Intra-office SONET/SDH
High bit-rate data communications
JDSU 10 Gb/s PH1 Series transponders are intended for 1550 nm system
applications with reaches of up to 80 km. The series includes three different
transponders for SR2 (25 km), IR2 (40 km), and LR2 (80 km) TDM or DWDM
applications. Each transponder accepts 16 bits of parallel digital data and converts
it to a 10 Gb/s NRZ modulated optical signal. It also accepts a 10 Gb/s NRZ
modulated optical signal and converts it into 16 bit wide parallel digital data.
The PH1 series offers low DC power dissipation and is available in either a small
form factor package (2.2 x 3 x 0.53 inches) or in a larger footprint (3.5 x 4.5 x 0.53
inches) package, depending on system thermal performance requirements. The
transmit design uses an Electro-Absorptive Modulated Laser (EML) which,
depending on the configuration, produces an average output power of between
-4 dBm to 2 dBm (EOL). A PIN (-17 dBm typical sensitivity) or APD (-24 dBm
typical sensitivity) receiver is available, based on system configurations.
JDSU PH1 Series transponders are designed to support the following data rates:
9.953 Gb/s (SONET), 10.3125 Gb/s (Ethernet), 10.664 Gb/s (FEC Encoded),
10.709 Gb/s FEC, or 11.09 Gb/s EFEC. They meet all applicable SONET/SDH standards.
Compliance
• Telcordia GR-253-Core
NORTH AMERICA
:
800 498-JDSU (5378)
WORLDWIDE
:
+800 5378-JDSU
WEBSITE
:
www.jdsu.com
How to use CF card as boot disk in Tornado2.2
I am going to use a CF card as a boot disk for VxWorks. I read some literature that says to use IDE DETECTION after entering BIOS to check the physical parameters of the CF card. However, there is no ...
xabc Embedded System
Can I directly port the BSP of wince4.2 to wince6.0?
I have a 2440 board with wince5.0 system. I looked at the BSP directory and found that it should be ported from wince4.2. The directory is the same as wince4.2. Now I want to port this system to wince...
caianlu Embedded System
Engine immobilizer system
Hello everyone: Does anyone have relevant information about the engine anti-theft locking system? For example, information about chips such as pcf7991AT and pcf7936? I looked it up on the Internet, bu...
DSZ Embedded System
I recently drew a PCB for stm32. Please point out any deficiencies.
I recently finished drawing a PCB with stm32 as the main control. The whole circuit is an electronic scale that can be connected to the Internet. Because it is the first time to draw a 32-bit board, t...
DB_DOG PCB Design
The stm32 library is not good
Seeking help from the heroes???...
xupujiang120 stm32/stm8
The 5-cent label was finally born
SmartCode breaks the price limit of EPC tags and launches the 5-cent Gen 2 tag product, claiming that as long as the end user orders 100 million tags at a time, the price of its RFID Gen 2 tag can be ...
tmily RF/Wirelessly

EEWorld
subscription
account

EEWorld
service
account

Automotive
development
circle

Robot
development
community

Index Files: 2924  245  2429  1767  1533  59  5  49  36  31 
Datasheet   0 1 2 3 4 5 6 7 8 9 A B C D E F G H I J K L M N O P Q R S T U V W X Y Z
Room 1530, 15th Floor, Building B, No. 18 Zhongguancun Street, Haidian District, Beijing Telephone: (010) 82350740 Postal Code: 100190
Copyright © 2005-2026 EEWORLD.com.cn, Inc. All rights reserved 京ICP证060456号 京ICP备10001474号-1 电信业务审批[2006]字第258号函 京公网安备 11010802033920号