I am preparing for the postgraduate entrance examination, and I feel reluctant to part with some of my unused boards that are gathering dust. I have no choice but to sell a few boards, chipkit32, LPC8...
In the ARM architecture, it can work in three different states: ARM state, Thumb state and Thumb-2 state, and debug state.
The Embedded System Development and Application Tutorial (2nd Edition) says t...
It is a very thin piece, and its function is similar to that of a solar panel, but it receives infrared light and outputs voltage. Once the infrared light is blocked, the output voltage will become lo...
Description: This code is the source code of the three-wire SPI interface (CS, SDA, SCK). General AD or DA devices or clock chips such as DS1302 use this interface. This code is an interface part of a...
Use the interrupt function of the GPIO port to identify the short and long keys in the LaunchPad. The short key will light up the red LED, and the long key will light up another LED for about 10ms.
#i...
For 80,000
ZTE
(000063.SZ) employees and more Chinese ICT (information and communication technology) industry practitioners, the news from across the ocean on the evening of April 16 kept t...[Details]
In the actual project development process, we often need to get the running time of a section of code. The usual method is to use an oscilloscope to measure it. This blog post will use SysTick to acc...[Details]
1. Photovoltaic inverter installation process
1. Preparation before installation
Are the product accessories, installation tools and parts complete? Is the installation environmen...[Details]
introduction In the general project development process, two or more microcontrollers are often required to communicate to complete data transmission. For example, a quadcopter wirelessly transmits d...[Details]
Timing and protocol are two key points in digital system debugging, and they are also where logic analyzers can play their most valuable role. How can we use a logic analyzer to quickly complete wiri...[Details]
As many companies listed with
the concept of
touch screen
begin to "transform and upgrade", the official voice of the TP industry is getting smaller and smaller. At the same time, the list o...[Details]
The photovoltaic inverter is the core equipment of the photovoltaic system. Its main function is to convert the direct current generated by the photovoltaic modules into alternating current that meets...[Details]
Using the WWDG of STM32F030, it is found that the MCU will not be reset under STOP, just like the sleep mode of STM8S. Paste the watchdog code: /******************************************************...[Details]
The storage media corresponding to the three boot modes of STM32 are built-in to the chip, they are: 1. User Flash = Flash built into the chip 2.SRAM = RAM area built into the chip, which is the m...[Details]
Note: This STM32 microcontroller is the STM32F103 series. The ADC of Stm32 has DMA function. This is beyond doubt and is what we use most! However, if we want to sample a signal (such as a pulse sign...[Details]
/* Unfortunately, it cannot generate a standard 38kHz frequency square wave, there is a little error*/ #include reg51.h #define uchar unsigned char #define uint unsigned int sbit Waveout=P1^0; //P...[Details]
When the program starts running, light A turns on for 5 seconds, then turns off, light B turns on for 5 seconds, light B turns off, light C turns on for 5 seconds, light C turns off, the program ends...[Details]
For complex calculations, the speed of the microcontroller is too slow. The best way is to manually calculate all the results in advance, store them in ROM in sequence, and then directly check the re...[Details]
Buy&Sell
京公网安备 11010802033920号
EEWORLD
