-
In early 2002, I started to write a working program for an IC card prepaid electricity meter. The meter used Philips' 8-bit 51-expanded single-chip microcomputer
87LPC764
, and wa...[Details]
-
No matter which processor you are learning, the first thing you need to understand is the registers and working mode of the processor.
ARM has 37 registers, including 31 general registers and ...[Details]
-
1 Introduction
Intelligent control instruments are one of the most commonly used controllers in industrial control. They are mainly aimed at a specific parameter (such as pressure, tempera...[Details]
-
With the widespread application of new services and technologies in the communications industry, the scale and capacity of operators' network construction are getting larger and larger, and the ris...[Details]
-
introduction
At present, the research on micron and nanotechnology is very active, which has led to the rapid development of microtechnology and micro-mechanical electronic system (MEMS) t...[Details]
-
When developing electronic products with processors, how to improve anti-interference ability and electromagnetic compatibility?
1. The following systems should pay special attention to anti-...[Details]
-
1 Introduction
The stepper motor is an actuator of an open-loop servo motion system, which is controlled in a pulse mode and outputs angular displacement. Compared with AC servo motors and DC servo ...[Details]
-
1. Sensor
According to the national standard GB7665-87, a sensor is defined as a device that can sense the specified measured quantity and convert it into a usable output signal according to a...[Details]
-
0 Introduction
In microwave, radar, radio and television, and communication systems, the problem of coupling RF power is often encountered. A directional coupler is a directional power divide...[Details]
-
: Ambiguous operators need parenthesesAmbiguous
symbol ``xxx``Argument
list syntax errorArray
bounds
missingArray
size
toolargeBad
character
in paramentersBad
file
name format in i...[Details]
-
When programming in C and assembly, there are interface issues between variables and functions in C and assembly.
Variables defined in a C program are put into the .bss area after being compile...[Details]
-
1. Introduction
According to the definition of the International Electrotechnical Commission (IEC) and the American Instrument Society (ISA), fieldbus is a digital, two-way transmission, multi...[Details]
-
1. Introduction
PROFIBUS is an international, open asynchronous serial communication standard, which is widely used in manufacturing automation and process automation, buildings, transportatio...[Details]
-
In order to reduce the proportion of data transmission time in the entire system processing time index, the data transmission rate should be no less than E1 (2.048Mb/s), and the communication...[Details]
-
This article examines some of the requirements that need to be met when designing DC/DC converters used in telecom and distributed power systems (DPS). Telecom DC/DC converters have an input voltag...[Details]
Analog electronics
京公网安备 11010802033920号
EEWORLD
