Features ....................................................................................................................................................................................... 1
Ordering Information .................................................................................................................................................................... 2
Revision History ......................................................................................................................................................................... 16
Rev 1.71
Page 3 of 16
www.sitime.com
SiT9367
220 MHz to 725 MHz Ultra-low Jitter Differential Oscillator
Electrical Characteristics
All Min and Max limits in the Electrical Characteristics tables are specified over temperature and rated operating voltage
with standard output termination shown in the termination diagrams. Typical values are at 25°C at nominal supply voltage.
Table 2. Electrical Characteristics – Common to LVPECL, Low-swing LVPECL, LVDS and HCSL
Parameter
Output Frequency Range
Frequency Stability
Symbol
f
F_stab
Min.
220.000001
-10
-20
-25
-50
First Year Aging
5 Year Aging
10 Year Aging
20 Year Aging
Operating Temperature Range
F_1y
F_5y
F_10y
F_20y
T_use
-0.7
-1.1
-1.3
-1.5
-20
-40
-40
-40
Supply Voltage
Vdd
2.97
2.70
2.52
2.25
Input Voltage High
Input Voltage Low
Input Pull-up Impedance
Duty Cycle
Startup Time
OE Enable/Disable Time
VIH
VIL
Z_in
DC
T_start
T_oe
70%
–
–
45
–
–
Typ.
–
–
–
–
–
±0.4
±0.7
±0.8
±1.0
–
–
–
–
3.30
3.00
2.80
2.50
–
–
100
–
–
–
Max.
725
+10
+20
+25
+50
+0.7
+1.1
+1.3
+1.5
+70
+85
+95
+105
3.63
3.30
3.08
2.75
–
30%
-
55
3.0
3.8
Unit
MHz
ppm
ppm
ppm
ppm
ppm
ppm
ppm
ppm
°C
°C
°C
°C
V
V
V
V
Vdd
Vdd
kΩ
%
ms
µs
Measured from the time Vdd reaches its rated minimum value.
f = 322.265625 MHz. Measured from the time OE pin reaches rated
VIH and VIL to the time clock pins reach 90% of swing and high-Z.
See
Figure 8
and
Figure 9
Pin 1, OE
Pin 1, OE
Pin 1, OE logic high or logic low
Extended Industrial
At 85°C
At 85°C
At 85°C
At 85°C
Extended Commercial
Industrial
Condition
Accurate to 6 decimal places
Inclusive of initial tolerance, operating temperature, rated power
supply voltage and load variations
Frequency Range
Frequency Stability
Temperature Range
Supply Voltage
Input Characteristics
Output Characteristics
Startup and OE Timing
Rev 1.71
Page 4 of 16
www.sitime.com
SiT9367
220 MHz to 725 MHz Ultra-low Jitter Differential Oscillator
Table 3. Electrical Characteristics – LVPECL Specific
Parameter
Current Consumption
OE Disable Supply Current
Output Disable Leakage Current
Maximum Output Current
Output High Voltage
Output Low Voltage
Output Differential Voltage Swing
Rise/Fall Time
Output High Voltage
Output Low Voltage
Output Differential Voltage
Swing
Rise/Fall Time
RMS Period
Jitter
[3]
Symbol
Idd
I_OE
I_leak
I_driver
VOH
VOL
V_Swing
Tr, Tf
VOH
VOL
V_Swing
Tr, Tf
T_jitt
T_phj
Min.
–
–
–
–
Vdd-1.15
Vdd-2.0
1.2
–
Typ.
–
–
0.15
–
–
–
1.6
225
Max.
94
63
–
33
Vdd-0.7
Vdd-1.5
2.0
330
Unit
mA
mA
A
mA
V
V
V
ps
Condition
Excluding Load Termination Current, Vdd = 3.3 V or 2.5 V
OE = Low
OE = Low
Maximum average current drawn from OUT+ or OUT-
See
Figure 4
See
Figure 4
See
Figure 5
20% to 80%, see
Figure 5
Current Consumption
Output Characteristics for LVPECL
Output Characteristics for Low-swing LVPECL
–
Vdd-1.2
Vdd-0.75
V
See
Figure 4
Vdd-1.8
0.4
0.4
–
–
–
–
1
1
225
1.0
0.220
Vdd-1.25
1.2
1.6
320
1.6
0.270
V
V
V
ps
Ps
Ps
See
Figure 4
Output frequency 1 to 220 MHz, See
Figure 5
Output frequency greater than 220 MHz, See
Figure 5
20% to 80%. See
Figure 5
f = 100, 156.25 or 212.5 MHz, Vdd = 3.3 V or 2.5 V
f = 322.265625 MHz, Integration bandwidth = 12 kHz to 20 MHz,
all Vdd levels, includes spurs. Temperature ranges -20 to 70ºC and
-40 to 85ºC.
f = 322.265625 MHz, Integration bandwidth = 12 kHz to 20 MHz,
all Vdd levels, includes spurs. Temperature ranges -40 to 95ºC and
-40 to 105ºC
f = 322.265625 MHz, IEEE802.3-2005 10GbE jitter mask
integration bandwidth = 1.875 MHz to 20 MHz, Includes spurs, all
Vdd levels
f = 100, 156.25 or 212.5 MHz, Vdd = 3.3 V or 2.5 V
f = 322.265625 MHz, Integration bandwidth = 12 kHz to 20 MHz,
all Vdd levels, includes spurs. Temperature ranges -20 to 70ºC and
-40 to 85ºC.
f = 322.265625 MHz, Integration bandwidth = 12 kHz to 20 MHz,
all Vdd levels, includes spurs. Temperature ranges -40 to 95ºC and
-40 to 105ºC
f = 322.265625 MHz, IEEE802.3-2005 10GbE jitter mask
integration bandwidth = 1.875 MHz to 20 MHz, Includes spurs, all
I have just made a 2812 board and I run the simplest program. The program can run normally on other 2812 boards, but it cannot run on this board. When debugging in RAM, I can single-step (F8) it, but ...
The teacher only told us to draw all the connection diagrams on an A3 paper, and then explain the principles. Please give me some advice and explain in more detail. Thank you....
2.1 Brief Introduction It is necessary to introduce the following series of chips and discrete devices. In addition to the microcontroller as the core of the controller, as a product, it is composed o...
I have also seen network programming before, and found that as long as you send to 127.0.0.1, you can receive it locally, or you can directly send a data packet to your own IP address and you can also...
As a wireless broadband metropolitan area network standard, WiMAX technology has greater advantages than previous 3.5GHz MMDS products in terms of non-line-of-sight transmission and spectrum utiliz...[Details]
0 Introduction
With the development of my country's economy, the number of motor vehicles continues to increase. The growth of existing roads and other hardware facilities can no longer meet t...[Details]
1. Introduction
Since the 1980s, with the continuous development of automotive electronic technology, there are more and more electronic control units in automobiles, such as electronic fuel i...[Details]
With the rapid development of urban economy, elevators are increasingly used as a vertical transportation tool. However, elevator fault detection and maintenance, especially the role of elevator remot...[Details]
Since the No. 4 blast furnace of Handan Iron and Steel was put into operation in 1993, its external equipment has been seriously aged, and the original PLC control system TDC3000 of the hot blast furn...[Details]
On the afternoon of July 10, Beijing time, Taiwan's largest chip designer MediaTek expects its smartphone chip shipments to grow by double digits in the third quarter of this year, and the company is ...[Details]
LED is the abbreviation of light emitting diode, which is an electric light source made of semiconductor technology. The core part of LED is a chip composed of P-type semiconductor and N-type semi...[Details]
LED lamps and bulbs are now rapidly replacing incandescent, halogen and CFL (compact fluorescent lamp) light sources in many general lighting applications. Flyback DC/DC converters are the power su...[Details]
In recent years, with the rapid development of the information industry, dot matrix LED display screens have been widely used in various advertising and information display systems such as the fina...[Details]
Capacitance Measurement
Used to verify that capacitors meet the manufacturer's specifications. For quality control, a group of capacitors may be placed in an environmental chamber and the cap...[Details]
Today, the value of electronic components in cars accounts for 15-20% of the total vehicle. In the future, this proportion may be as high as 30-40% as more safety electronics, fuel consumption and ...[Details]
It is well known to automotive suppliers that automakers are demanding more from their supply base. For connector suppliers, this means stricter requirements for product performance, stability and ...[Details]
Introduction
Automakers are working to reduce vehicle weight to reduce CO2 emissions and improve fuel efficiency. Designers are therefore seeking new technologies and design techniques that can...[Details]
The era of mobile access to the Internet has arrived, and it will rapidly change the business and infrastructure needs of mobile operators under a whole new trend of requirements. We need 4G LTE to...[Details]
Since AC mains power may experience power outages, voltage sags and surges, continuous undervoltage and overvoltage, and frequency fluctuations during supply, these factors will affect the continuous ...[Details]
Analog electronics
京公网安备 11010802033920号
EEWORLD
