-
1 Introduction
The high temperature tester is mainly used for temperature tracking measurement and data acquisition during the heating process. By systematically analyzing the test data, the...[Details]
-
When the WDP500-2A plane grating monochromator is used to test the emission wavelength of a high-power laser diode at different currents, the matching of the laser diode has the disadvantages of lo...[Details]
-
0 Introduction
With the rise and continuous improvement of the solid-state lighting industry, light-emitting diodes (LEDs) have become an alternative lighting technology and are gr...[Details]
-
Today, with energy becoming increasingly scarce, the utilization of natural energy has become the focus of people's attention. Among various natural energies, the endless solar energy is highly fav...[Details]
-
HL201A is a special thick film driver integrated circuit with a capacity of less than 75AGTR developed by Xi'an Power Electronics Technology Research Institute. The article explains the pin arrange...[Details]
-
1 Introduction
Automatic Test
System The ATS (Automatic Test System) integrates all the stimulus and measurement equipment required for testing.
The computer
efficiently comp...[Details]
-
1. Introduction
AS-Interface bus technology is an intelligent network that uses a single cable to connect sensors and actuators to controllers, transmit data, and provide power. It can be used...[Details]
-
TPMS is the abbreviation of "Tire Pressure Monitoring System". It is mainly used to automatically monitor the tire pressure in real time when the car is driving, and to alarm for tire leakage and l...[Details]
-
(1) Open circuit voltage of the battery
(2) Internal resistance of the battery
(3) Battery operating voltage
(4) Charging voltage
Charging voltage refers to the voltage applied ...[Details]
-
Some experience we have accumulated when debugging a system using Keil C
1. Since Keil C does not support Chinese very well, the displayed cursor will be inconsistent with the actual cursor positi...[Details]
-
Engineers usually use multiple groups of cheap small-capacity batteries in parallel to achieve the larger battery capacity required by UPS. If multiple groups of batteries with poor performance uni...[Details]
-
LED lamp beads are voltage-sensitive devices and capacitive loads. In actual work, the current accuracy is required to be high, which is one of the main issues affecting the luminous efficiency and...[Details]
-
Modern smartphones are sleek and powerful, and while the size of the phone varies depending on the model, in general, a state-of-the-art device packs a lot of features into a package that measure...[Details]
-
This design uses AT89C51 microcontroller as the core and 4*4 matrix keyboard as input to control the start, stop, speed and direction of the DC motor, completing the basic requirements and the requ...[Details]
-
Preface
For a new antenna, we usually care about its
three main performance indicators:
standing wave
coefficient, gain and radiation pattern. In a suitable microwave darkroom, these th...[Details]
DigiKey Technology Zone
京公网安备 11010802033920号
EEWORLD
