All technical data relates to an ambient temperature of +25°C. Capacitance and DF are measured at 120Hz, 0.5V RMS with a maximum DC bias of 2.2 volts. DCL is measured at rated voltage after 5 minutes.
NOTE: KYOCERA AVX reserves the right to supply a higher voltage rating or tighter tolerance part in the same case size, to the same reliability standards.
42
The Important Information/Disclaimer is incorporated in the catalog where these specifications came from or available
online at www.kyocera-avx.com/disclaimer/ by reference and should be reviewed in full before placing any order.
041520
–
high reliability tantalum capacitors
–
TBJ SERIES
CWR11 - MIL-PRF-55365/8 Established Reliability,
COTS-Plus & Space Level
RATING & PART NUMBER REFERENCE
CWR11 P/N
CWR11K^156*@+
CWR11M^104*@+
CWR11M^154*@+
CWR11M^224*@+
CWR11M^334*@+
CWR11M^474*@+
CWR11M^684*@+
CWR11M^105*@+
CWR11M^155*@+
CWR11M^225*@+
CWR11M^335*@+
CWR11M^475*@+
CWR11M^685*@+
CWR11N^104*@+
CWR11N^154*@+
CWR11N^224*@+
CWR11N^334*@+
CWR11N^474*@+
CWR11N^684*@+
CWR11N^105*@+
CWR11N^155*@+
CWR11N^225*@+
CWR11N^335*@+
CWR11N^475*@+
COTS-Plus P/N
TBJ D 156 * 025 C
# @ 0 ^ ++
TBJ A 104 * 035 C
# @ 0 ^ ++
TBJ A 154 * 035 C
# @ 0 ^ ++
TBJ A 224 * 035 C
# @ 0 ^ ++
TBJ A 334 * 035 C
# @ 0 ^ ++
TBJ B 474 * 035 C
# @ 0 ^ ++
TBJ B 684 * 035 C
# @ 0 ^ ++
TBJ B 105 * 035 C
# @ 0 ^ ++
TBJ C 155 * 035 C
# @ 0 ^ ++
TBJ C 225 * 035 C
# @ 0 ^ ++
TBJ C 335 * 035 C
# @ 0 ^ ++
TBJ D 475 * 035 C
# @ 0 ^ ++
TBJ D 685 * 035 C
# @ 0 ^ ++
TBJ A 104 * 050 C
# @ 0 ^ ++
TBJ B 154 * 050 C
# @ 0 ^ ++
TBJ B 224 * 050 C
# @ 0 ^ ++
TBJ B 334 * 050 C
# @ 0 ^ ++
TBJ C 474 * 050 C
# @ 0 ^ ++
TBJ C 684 * 050 C
# @ 0 ^ ++
TBJ C 105 * 050 C
# @ 0 ^ ++
TBJ D 155 * 050 C
# @ 0 ^ ++
TBJ D 225 * 050 C
# @ 0 ^ ++
TBJ D 335 * 050 C
# @ 0 ^ ++
TBJ D 475 * 050 C
# @ 0 ^ ++
Parametric Specifications by Rating per MIL-PRF-55365/8
All technical data relates to an ambient temperature of +25°C. Capacitance and DF are measured at 120Hz, 0.5V RMS with a maximum DC bias of 2.2 volts. DCL is measured at rated voltage after 5 minutes.
NOTE: KYOCERA AVX reserves the right to supply a higher voltage rating or tighter tolerance part in the same case size, to the same reliability standards.
The Important Information/Disclaimer is incorporated in the catalog where these specifications came from or available
online at www.kyocera-avx.com/disclaimer/ by reference and should be reviewed in full before placing any order.
[i=s]This post was last edited by dcexpert on 2017-5-6 14:45[/i] [font=Tahoma, Helvetica, SimSun, sans-serif]Life game is a widely played game, and also a mathematical/philosophical problem. I won't s...
Company: Canon Position: R&D Engineer Language: c/c++ Platform: WINCE Experience: 3 years and above Location: Beijing If you are interested, please contact msn: mygy2006@hotmail.com 13910500391...
There has been no DA module in msp430F149 for ten years, so I would like to ask if anyone has used DA5571. I would like to ask how to use this chip and how to simulate the I2C clock. If there is code ...
Refer to the posts of the masters in the forum. When copying the running program from FLASH to RAM, the LOAD of ramfuncs in CMD should be changed from FLASHD to FLASHA. I am a little curious why in th...
I downloaded the written program to my CC2530 development board. The program is very simple, that is, the terminal node sends a data to the coordinator, and then drives the relay switch connected to t...
Traditional broadcasting systems generally need to be operated manually at a fixed time, and can only realize one-way broadcasting with few functions. Traditional bell ringing equipment has a singl...[Details]
This program is written to simulate the serial port hardware mechanism. When used, a timed interrupt can be set with a time interval of 1/4 baud rate. The receiving function is called once for ea...[Details]
Assume that data is read from 8-bit AD (if it is a higher-bit AD, the data type can be defined as int), the subroutine is get_ad();
1. Limited secondary filtering
/* A value can be adjust...[Details]
1. Circuit composition
The whole circuit consists of two parts:
1. Power saving control circuit
As shown in the figure below. Including delay circuit and drive circuit.
(1) Delay ci...[Details]
At present, the traffic congestion in cities is quite serious. According to relevant news reports: In China, the traffic congestion has expanded from megacities such as Beijing, Shanghai, and Guang...[Details]
1. Introduction
With the growth of parking demand, the scale of parking lots is becoming larger and larger. A lot of research has been done on intelligent parking lots in China, but most of th...[Details]
Floating-point digital signal processing has become a constant requirement for precision technology, often in applications requiring high accuracy in areas such as aviation, industrial machinery, a...[Details]
Converged processors meet scalability requirements
In current embedded system design, solutions based on MCU, DSP, FPGA and ASIC account for more than 90% of the market share. These solutions ...[Details]
1 Introduction
Solar street lights are mainly composed of four parts: solar photovoltaic cell components, batteries, charge and discharge controllers, and lighting fixtures. The bo...[Details]
DSP (digital signal processor) is used more and more frequently in today's engineering applications. There are three main reasons for this: first, it has powerful computing power and is capable of ...[Details]
With the rapid development of urban economy, elevators are increasingly used as a vertical transportation tool. However, elevator fault detection and maintenance, especially the role of elevator remot...[Details]
LED is the abbreviation of light emitting diode, which is an electric light source made of semiconductor technology. The core part of LED is a chip composed of P-type semiconductor and N-type semi...[Details]
Overview
In spectral measurement, photomultiplier tubes (PMT) and charge-coupled devices (CCD) are often used as photoelectric converters. PMT is used in slow-changing, high-precision spectral...[Details]
Printed circuit boards ( PCBs
)
are used in most electrical products
. If a PCB has low
insulation resistance
(IR), the performance of the circuits on the PCB will be greatly reduced...[Details]
It is well known to automotive suppliers that automakers are demanding more from their supply base. For connector suppliers, this means stricter requirements for product performance, stability and ...[Details]
MicroPython Open Source section
京公网安备 11010802033920号
EEWORLD
