Siemens plc200 controls water pumps AB. Water pump A 2.2KW requires direct start and stop. Water pump B 3.7KW requires forward and reverse selection switches, start and stop, remote local control, and...
Introduction
Among the difficult challenges that system designers face are shortened design cycles, evolving standards, and system deployments in remote locations. Cyclone III devices help overcome th...
[TI's First Low Power Design Competition] + Connect BLE for master-slave communication MSP430FR5969 reads the left and right slider coordinates and sends the data to the master BLE via UART, and then ...
[align=left]Using the single-chip microcomputer stc89C2051 and mpc006 micro motion control module as the core of the control system, the three-way stepper motor is controlled to do motion experiments....
The problem of FIFO constantly sending interrupts has been solved. For details, please refer to the following reference. Thank you [color=#000][font=Helvetica, Arial, sans-serif][size=12px][b][url=htt...
Frequency conversion and automatic control With the rapid development of science and technology, variable frequency speed regulation has been widely used in various production fields, among which va...
1. Introduction
RFID (radio frequency identification) is a non-contact automatic identification technology that emerged in the 1990s. It uses the characteristics of radio frequency signal prop...[Details]
Sailing is gaining more and more attention. How to use modern technology to assist training and improve competition results is particularly important. Considering the real-time data collection in t...[Details]
1. Overview
Will passive devices
produce nonlinear intermodulation distortion? The answer is yes! Although there is no systematic theoretical analysis, it has been found in engineerin...[Details]
As a wireless broadband metropolitan area network standard, WiMAX technology has greater advantages than previous 3.5GHz MMDS products in terms of non-line-of-sight transmission and spectrum utiliz...[Details]
Electronic systems are located at different points on the automotive power bus and therefore often need to operate under very stringent power requirements. These include load dump, cold crank, very lo...[Details]
From the PIC16F946 datasheet, we know that there are two ways to write values to the LCD for display:
1. Directly write the value to LCDDATA1~LCDDATA23
2. Use disconnect t...[Details]
1 Introduction
Building Automation System (BAS) is a distributed monitoring system (DCS) designed according to distributed information and control theory. It is the result of the mutual de...[Details]
1 Introduction
With the development of control, computer, communication, network technology, etc., a new control technology, namely fieldbus, has emerged in the field of industrial control...[Details]
1. Introduction
Testing the temperature of steel billets before rolling is an important measure to ensure the quality of steel. Traditional manual testing is difficult to ensure product qu...[Details]
Abstract: With the development and construction of BeiDou II system, China will shift from the situation dominated by GPS to the situation dominated by BeiDou II global navigation system independen...[Details]
The rectified DC voltage is then converted back to AC using power electronics such as insulated gate bipolar transistors.
The output voltage is switched on and off at a high frequency, control...[Details]
Introduction
Nowadays, people pay more and more attention to the security alarm system, and people have higher and higher requirements for the functions and performance of the alarm. This paper prop...[Details]
With the rapid development of wireless
digital communication
, more challenges have been raised for integrated circuit design and testing. In the product design stage, in order to ensure
t...[Details]
The launch of Shenzhou IX is imminent, and Tiangong is welcoming visitors again. Yesterday, Professor Fu Qiang, Vice President of the Institute of Science and Industrial Technology of Harbin Instit...[Details]
Multimedia processors are often the most power-hungry devices in portable electronic devices. Common ways to reduce CPU power requirements are to reduce clock frequency or operating voltage, but th...[Details]
Industrial Control Electronics
京公网安备 11010802033920号
EEWORLD
