INFORMATION IN THIS DOCUMENT IS PROVIDED IN RELATION TO SAMSUNG PRODUCTS, AND IS SUB-
JECT TO CHANGE WITHOUT NOTICE.
NOTHING IN THIS DOCUMENT SHALL BE CONSTRUED AS GRANTING ANY LICENSE, EXPRESS OR
IMPLIED, BY ESTOPPEL OR OTHERWISE,
TO ANY INTELLECTUAL PROPERTY RIGHTS IN SAMSUNG PRODUCTS OR TECHNOLOGY. ALL INFOR-
MATION IN THIS DOCUMENT IS PROVIDED
ON AS "AS IS" BASIS WITHOUT GUARANTEE OR WARRANTY OF ANY KIND.
1. For updates or additional information about Samsung products, contact your nearest Samsung office.
2. Samsung products are not intended for use in life support, critical care, medical, safety equipment, or similar applications
where Product failure couldresult in loss of life or personal or physical harm, or any military or defense application, or any
governmental procurement to which special terms or provisions may apply.
* Samsung Electronics reserves the right to change products or specification without notice.
-1-
Revision 1.2
October 2006
K8C56(57)15ET(B)M
Document Title
NOR FLASH MEMORY
256M Bit (16M x16) Sync Burst , Multi Bank MLC NOR Flash Memory
Revision History
Revision No.
0.0
0.5
0.6
History
Initial
Preliminary
- Added Burst Access time(11ns@66Mhz, 9ns@83Mhz)
- Correct the Active Write Current (typ.15mA, max.30mA --> typ.25mA,
max.40mA)
- Correct tBDH(Data Hold Time from Next Clock Cycle) from
4ns(@66MHz), 2.25ns(@108MHz), 1.5ns(@133MHz) to
3ns(@66MHz), 2ns(@108MHz), 2ns(@133MHz)
- Correct tRDYA(Clock to RDY Setup Time) from 8ns(@83Mhz) to
9ns(@83MHz)
- Correct tRDYS(RDY setup to Clock) from 4ns(@66MHz),
2.25ns(@108MHz), 1.5ns(@133MHz) to 3ns(@66MHz),
2ns(@108MHz), 2ns(@133MHz)
- Correct typo
- Add Ordering Information for Density
56 : 256Mb for 66/83MHz, 57 : 267Mb for 108/133Mhz
- Add Product Classification Table (Table 1-1)
- Change tAVDH(AVD Hold Time from CLK) from 6ns(@66MHz),
5ns(@83MHz) to 2ns(@66/83MHz)
- Delete tOH(
Output Hold Time from Address, CE or OE ) from Asynchronous
Read parameter
Draft Date
April 1, 2005
September 1, 2005
November 7, 2005
Remark
Advance
Preliminary
Preliminary
0.7
December 7, 2005
Preliminary
0.8
- CFI note is added (Max Operation frequency : Data 53H is in 66/83Mhz
part
- tAVDO is deleted
- Specification is finalized
April 04,2006
Preliminary
1.0
April 25,2006
1.1
Active Asynchronous read Current(@1Mhz) is changed
September 08,2006
3mA(typ.),5mA(max.) to 8mA(typ.), 10mA(max.)
'In erase/program suspend followed by resume operation, min. 200ns is
needed for checking the busy status' is added
Frequency information is added to Programmable Wait State at Burst
Mode Configuration Register Table.
"Asynchronous mode may not support read following four sequential invalid
read condition within 200ns." is added
Correct typo
October 17, 2006
In write buffer programming part, "And from the third cycle to the last cycle
of Write to Buffer command is also required when using Write-Buffer-Pro-
gramming features in Unlock Bypass mode." is added.
1.2
-2-
Revision 1.2
October 2006
K8C56(57)15ET(B)M
Table of Contents
NOR FLASH MEMORY
FEATURES ...................................................................................................................................................................... 1
GENERAL DESCRIPTION ............................................................................................................................................... 1
ORDERING INFORMATION ............................................................................................................................................ 5
Continuous Linear Burst Read......................................................................................................................... 21
8-, 16-Word Linear Burst Read .................................................................................................................. 21
Programmable Wait State .......................................................................................................................... 22
Program ...................................................................................................................................................................... 24
Program Suspend / Resume....................................................................................................................................... 27
Read While Write Operation ....................................................................................................................................... 27
Deep Power Down ...................................................................................................................................................... 27
FLASH MEMORY STATUS FLAGS ................................................................................................................................. 29
DQ7 : Data Polling ...................................................................................................................................................... 29
ABSOLUTE MAXIMUM RATINGS ................................................................................................................................... 33
Revision 1.2
October 2006
-1-
K8C56(57)15ET(B)M
Table of Contents
NOR FLASH MEMORY
RECOMMENDED OPERATING CONDITIONS ( Voltage reference to GND ) ................................................................ 34
DC CHRACTERISTICS .................................................................................................................................................... 34
AC TEST CONDITION ..................................................................................................................................................... 35
AC CHARACTERISTICS................................................................................................................................................. 35
Crossing of First Word Boundary in Burst Read Mode..................................................................................................... 47
Case1 : Start from "16N" address group..................................................................................................................... 48
Case2 : Start from "16N+2" address group................................................................................................................. 48
Case3 : Start from "16N+3" address group................................................................................................................. 49
Case4 : Start from "16N+15" address group............................................................................................................... 49
Case5 : Start from "16N+15" address group............................................................................................................... 50
-2-
Revision 1.2
October 2006
K8C56(57)15ET(B)M
NOR FLASH MEMORY
256M Bit (16M x16) Synch Burst , Multi Bank MLC NOR Flash Memory
FEATURES
•
Single Voltage, 1.7V to 1.95V for Read and Write operations
When using C2000, engineers often say that the chip simulation can run, but the stand-alone run cannot run; or when debugging, reset the chip > run, and find that the program cannot run. The main reas...
Today I wanted to find a way to make the STM32F4DISCOVERY development board support printf without serial line, so I searched it on Google and found that it can be achieved. First, download the ST-LIN...
Danaher Motion, a provider of motion control solutions, has launched its latest motion control software, Motion Programming Interface (MPI) 3.04, a C-language software for motion control engineers. Th...
Today I would like to share with you my personal experience of playing with BB-Black. But I would like to apologize to the staff of EEWORLD first. Since I don’t know how to set up a blog on eeworld on...
At the suggestion of EEworld forum member zhaojun_xf, we added the ranking of featured posts and moderator rankings (only moderators can see) to the forum homepage ([url]https://home.eeworld.com.cn/fo...
1. Overview
Will passive devices
produce nonlinear intermodulation distortion? The answer is yes! Although there is no systematic theoretical analysis, it has been found in engineerin...[Details]
Remote keyless entry (RKE) systems have become popular with users, with more than 80% of new cars in North America and more than 70% in Europe equipped with RKE systems. In addition to the obvious ...[Details]
In recent years, lighting has become an important area that countries around the world are targeting to promote energy conservation and environmental protection. According to statistics, about 20% ...[Details]
This paper establishes a fuel cell engine test platform based on the NI integrated hardware and software environment. This platform can realize the test and control of fuel cell engines and their a...[Details]
A standard cell
is an electrochemical
cell
used as a voltage reference standard in many electrical standards laboratories
. If properly maintained, standard cells are very stable. The ...[Details]
On the afternoon of July 10, Beijing time, Taiwan's largest chip designer MediaTek expects its smartphone chip shipments to grow by double digits in the third quarter of this year, and the company is ...[Details]
Abstract: The output of high-range acceleration sensor is less than 10 mV under the excitation of small signal. The noise of traditional test system may cover such small voltage signal, so that hig...[Details]
Analysis of the three core aspects of digital TV transmission standards
According to the differences in regionality, transmission method and modulation method, the transmission method needs to...[Details]
Among the uses of electrical energy, lighting accounts for a considerable proportion. Compared with the earlier ordinary incandescent lamps, the fluorescent lamps and energy-saving lamps we commonl...[Details]
Movpower is a portable power bank. It can charge most mobile phones and digital products, such as digital cameras, PDAs, and mobile phones such as Apple, iPod, Blackberry, Motorola, Samsung, Nokia,...[Details]
The future energy storage hotspot is not coal or iron ore, but lithium. This lightest metal in nature may be the heaviest resource in the future energy landscape. China launched an ambitious electr...[Details]
introduction
The core features of mobile value-added service products are mobility, immediacy and personalization. Mobile value-added services are a new service mode that is rapidly developing...[Details]
1 Introduction to the overall system solution
The hardware part is mainly used to amplify the sound. When the sound is loud enough, the signal can be introduced into the microcontroller for de...[Details]
Designing low power circuits while achieving acceptable performance is a difficult task. Doing so in
the RF
bands increases the challenge dramatically. Today, nearly everything has wireless...[Details]
1. Introduction
Modern modular machine tools are equipped with a large number of electronic devices to meet the requirements of processing accuracy, processing speed, etc. If the conventional ...[Details]
Microcontroller MCU
京公网安备 11010802033920号
EEWORLD
