PH1-7LHSC2562 datasheet, PDF - EEWORLD Datasheet

Datasheet> All Categories > Wireless rf/communication> Optical fiber> PH1-7LHSC2562

PH1-7LHSC2562: DescriptionTransponder, 10709Mbps(Tx), 10709Mbps(Rx), SC/UPC Connector,; CategoryWireless rf/communication Optical fiber; File Size240KB，6 Pages; ManufacturerLumentum Operations LLC

Download Datasheet Parametric View All

PH1-7LHSC2562 Overview

Transponder, 10709Mbps(Tx), 10709Mbps(Rx), SC/UPC Connector,

PH1-7LHSC2562 Parametric

Parameter Name	Attribute value
Objectid	4000974828
Reach Compliance Code	compliant
Other features	IT ALSO OPERATE FROM 1280NM TO 1600NM
body height	13.2 mm
Body length or diameter	84.1 mm
Connection Type	SC/UPC CONNECTOR
Data rate (receive)	10709 Mbps
Data rate (send)	10709 Mbps
Emitter/Detector Type	AVALANCHE PHOTODIODE
Fiber optic equipment types	TRANSCEIVER, TRANSPONDER
Nominal operating wavelength	1528 nm
Nominal optical power output	2.511 mW
minimum return loss	-27 dB
Sensitivity	-24 dBm

Preview

Download Datasheet

View All

COMMUNICATIONS MODULES & SUBSYSTEMS

10 Gb/s TDM/DWDM 300 Pin SFF MSA SR2/IR2/LR2 Transponder

PH1 Series

Key Features

• Three configurations supporting SR2/IR2/LR2 applications

• Supports dense wavelength division multiplexing

(DWDM) applications (without wavelocker)

• Microprocessor controls to support I2C

• Integrated 16:1/1:16 mux/demux

• Small form factor package (2.2" x 3.0" x 0.53") for high

density applications

• Low power consumption: 4.8 W typical, 6.8 W maximum

for TDM applications

• 70 °C maximum operating temperature

• High sensitivity PIN or APD receivers

• SONET, FEC, Ethernet and Multirate Capable Versions

• Forward, counter and line timing clocking modes

Applications

•

Telecommunications

Metropolitan Area Networks

Subscriber loop

Intra-office SONET/SDH

High bit-rate data communications

JDSU 10 Gb/s PH1 Series transponders are intended for 1550 nm system

applications with reaches of up to 80 km. The series includes three different

transponders for SR2 (25 km), IR2 (40 km), and LR2 (80 km) TDM or DWDM

applications. Each transponder accepts 16 bits of parallel digital data and converts

it to a 10 Gb/s NRZ modulated optical signal. It also accepts a 10 Gb/s NRZ

modulated optical signal and converts it into 16 bit wide parallel digital data.

The PH1 series offers low DC power dissipation and is available in either a small

form factor package (2.2 x 3 x 0.53 inches) or in a larger footprint (3.5 x 4.5 x 0.53

inches) package, depending on system thermal performance requirements. The

transmit design uses an Electro-Absorptive Modulated Laser (EML) which,

depending on the configuration, produces an average output power of between

-4 dBm to 2 dBm (EOL). A PIN (-17 dBm typical sensitivity) or APD (-24 dBm

typical sensitivity) receiver is available, based on system configurations.

JDSU PH1 Series transponders are designed to support the following data rates:

9.953 Gb/s (SONET), 10.3125 Gb/s (Ethernet), 10.664 Gb/s (FEC Encoded),

10.709 Gb/s FEC, or 11.09 Gb/s EFEC. They meet all applicable SONET/SDH standards.

Compliance

• Telcordia GR-253-Core

NORTH AMERICA

800 498-JDSU (5378)

WORLDWIDE

+800 5378-JDSU

WEBSITE

www.jdsu.com

Recommended Resources

One of the single-junction transistor trigger circuits that is not affected by power grid fluctuations

14 groups of colorful light chain circuits that flash in cycles

Contactless range hood control circuit

DC converter circuit for servo instrument

Window comparator circuit diagram 2

555 simple motor phase failure and overcurrent protection device circuit

msp-FET430UIF: When emulating, it prompted me to upgrade, I confirmed it, but it got stuck during the upgrade, so I turned it off. When I connected it again, both indicator lights on the emulator were off. I saw fro...; qewrty Microcontroller MCU

【Design Tools】SDRAM controller soft core Verilog design: ...; 8fu8 FPGA/CPLD

Regarding the learning journey of a rookie, please give me some advice.: At the beginning, I thought that if I could learn MCU by myself and then move up to the level of embedded system, I would succeed slowly. But I felt more and more that self-study was not feasible. The...; 932212098 MCU

City Lord, I would like to ask about the OTG problem of STM32F105RB!: I want to use STM32F105RB to make products, and upgrade them on site through a USB flash drive! Is it possible? I have never used USB OTG. The ones I used before were either host or device.In addition...; Teuton stm32/stm8

MSP430F5438 clock system: MSP430F5438 clock system To understand a chip, the most intuitive thing is the official chip features (FEATURES); to use a chip well, you must understand the various functions of the chip from the dat...; 火辣西米秀 Microcontroller MCU

Repair of FOTILE embedded electric steamer, the water level sensor failed and the circuit was broken because of a small resistor: A colleague came to ask for help, saying that his Fotile electric steamer can operate normally, but it does not heat up. This is a large built-in iron box, which is not cheap and is usually used to st...; buildele Power technology

Shortcut: A0 A1 A2 A3 A4 A5 A6 A7 A8 A9 AA AB AC AD AE AF AG AH AI AJ AK AL AM AN AO AP AQ AR AS AT AU AV AW AX AY AZ B0 B1 B2 B3 B4 B5 B6 B7 B8 B9 BA BB BC BD BE BF BG BH BI BJ BK BL BM BN BO BP BQ BR BS BT BU BV BW BX BY BZ C0 C1 C2 C3 C4 C5 C6 C7 C8 C9 CA CB CC CD CE CF CG CH CI CJ CK CL CM CN CO CP CQ CR CS CT CU CV CW CX CY CZ D0 D1 D2 D3 D4 D5 D6 D7 D8 D9 DA DB DC DD DE DF DG DH DI DJ DK DL DM DN DO DP DQ DR DS DT DU DV DW DX DZ

Popular Components