[i=s] This post was last edited by learntest on 2019-4-15 12:25 [/i]Where does he get this 26mV? ? 26mV should be the voltage of VE, right? Because re=26mV/ie, but why is ve 1.2v? 81*(26mv/ie)=50 ohms...
[size=4]There are three CMD files officially provided by TI: 28335_RAM_lnk.cmd, F28335.cmd, DSP2833x_Headers_nonBIOS.cmd[/size] [size=4] [/size] [size=4]When debugging the program, add the 28335_RAM_l...
For those who love boards, it is a happy thing to see a good board for free evaluation. Now, I want to tell you that there are many good board evaluation activities online in the forum recently. Will ...
[align=left][color=rgb(62, 62, 62)]It's not so much about developing embedded software as it is about debugging embedded software. Software is debugged. Unfortunately, it's the most disliked thing for...
[i=s] This post was last edited by paulhyde on 2014-9-15 03:27 [/i] I found a circuit with automatic gain control on the Internet. After simulating it with multisim, the output of the latter stage is ...
A single-chip microcomputer is also called a single-chip microcontroller. It is not a chip that completes a certain logical function, but a computer system integrated into one chip. In general, a c...[Details]
1. Introduction
RFID (radio frequency identification) is a non-contact automatic identification technology that emerged in the 1990s. It uses the characteristics of radio frequency signal prop...[Details]
As cellular phones become more advanced, the power consumption of the system during operation and the power consumption during standby are also increasing. Therefore, the power management design of...[Details]
introduction
For the voltage regulator modules (VRMs) that power the latest computer central processing units (CPUs), power supply designers have historically used multiphase interleaved b...[Details]
Electronic systems are located at different points on the automotive power bus and therefore often need to operate under very stringent power requirements. These include load dump, cold crank, very lo...[Details]
1. Introduction
Testing the temperature of steel billets before rolling is an important measure to ensure the quality of steel. Traditional manual testing is difficult to ensure product qu...[Details]
The most important components of new energy electric vehicles are power batteries, electric motors and energy conversion control systems. The power battery must achieve high performance such as fas...[Details]
Multimedia processors are often the most power-hungry devices in portable electronic devices. Common ways to reduce CPU power requirements are to reduce clock frequency or operating voltage, but th...[Details]
With the popularity of digital appliances, rechargeable batteries can be seen everywhere in people's daily lives and have become one of the indispensable daily necessities.
This article gives ...[Details]
1 Introduction
At present, advocating health has become the focus of people's attention, and the emergence of treadmills has become more and more popular. People can exercise at home or in the ...[Details]
introduction
Belt drive is a common transmission device used in industrial production. Its commonly used speed detection device is a photoelectric encoder installed at the rotating end of th...[Details]
0 Introduction
PROFIBUS is an open digital communication system with a wide range of applications, which has been included in the international standards IEC 61158 and IEC 61784. Since the gen...[Details]
TMC428 is a stepper motor motion controller from TRINAMIC. It can reduce the workload of motor control software design and development costs. The 3-axis stepper motor drive control system based on ...[Details]
Stepper motors, also called steppers, use the principles of electromagnetism to convert electrical energy into mechanical energy and have been used since the 1920s. With the increasing popularity o...[Details]
0 Introduction
The load with impact (rapid change) power in the power system will cause the voltage fluctuation and flicker of the power grid, causing many electrical equipment to fail to wo...[Details]