FRAM, also known as Ferroelectric Random Access Memory, is a memory technology that combines the non-volatility of Flash with the flexibility and low power consumption of SRAM. The MSP430 ultra-low-po...
This program is a small program from Gong Jun's S3C44BO_BIOS. I really don't understand it. Can anyone analyze it??? if((prog_begin==0)&&overwrite0) { unsigned int ins; ins = *(unsigned int *)data_beg...
I haven't received it yet. The TI Cup will be held on August 5th. I have 4 groups of students and only have 3 launchpads. I just need one. I hope it can be delivered to me before the competition....
Because I have developed some projects, I have made some 51 series circuit boards, SMD design, with AD conversion, using thyristor output, can drive 220v/500w load (single channel), is there any need?...
The purple part in the picture may be connected to 220V mains power
To reduce the configuration resistor,can I use a 1N4007 to isolate 24V and 220V?
When the high voltage circuit is connected to 220V,...
As cellular phones become more advanced, the power consumption of the system during operation and the power consumption during standby are also increasing. Therefore, the power management design of...[Details]
In recent years, with the rapid development of the information industry, dot matrix LED display screens have been widely used in various advertising and information display systems such as the fina...[Details]
Today, the value of electronic components in cars accounts for 15-20% of the total vehicle. In the future, this proportion may be as high as 30-40% as more safety electronics, fuel consumption and ...[Details]
0 Introduction
High-precision current source can provide high-precision current supply for precision instruments, and is suitable for automatic measurement tasks of various resistors in semico...[Details]
With the continuous advancement of various technologies in the field of measurement and control, the baseband subsystem of general measurement and control equipment has entered the fourth generation o...[Details]
Abstract: Based on the ZigBee parking lot SMS car search system, the location of the vehicle in the parking lot is sent to the owner through SMS, which is convenient for the owner to quickly find ...[Details]
In industry, voltage 0…5 (10) V or current 0 (4)…20 mA is usually used as a method for analog signal transmission, which is also a method often used by programmable controllers. So what are the dif...[Details]
Direct digital frequency synthesis (DDS) has fast frequency switching and modulation capabilities and is widely used. However, when low power consumption and low cost are the main considerations, D...[Details]
With the popularity of digital appliances, rechargeable batteries can be seen everywhere in people's daily lives and have become one of the indispensable daily necessities.
This article gives ...[Details]
1. Introduction
AS-Interface bus technology is an intelligent network that uses a single cable to connect sensors and actuators to controllers, transmit data, and provide power. It can be used...[Details]
0 Introduction
PROFIBUS is an open digital communication system with a wide range of applications, which has been included in the international standards IEC 61158 and IEC 61784. Since the gen...[Details]
As a type of iron battery, lithium iron phosphate battery (hereinafter referred to as lithium iron battery) has always been widely concerned by industry friends (some people say that lithium iron b...[Details]
Hall sensor
is a semiconductor element that works by using the Hall effect. Due to the high conversion efficiency, fast response speed, wide dynamic range, good frequency characteristics and ...[Details]
illustrate]
This method has
the characteristics of small
ROM
occupation
and fast operation speed, with a range of
2000
ßà
2099
,
a total of
...[Details]
The development of the machinery manufacturing industry from single-machine automation to distributed DNC control systems requires the first technical solution to the information exchange and inter...[Details]