Capacitance Change with Reference to +25°C and 0 Vdc Applied (TCC)
Aging Rate (Max % Cap Loss/Decade Hour)
Dielectric Withstanding Voltage
Dissipation Factor (DF) Maximum Limit @ 25ºC
Insulation Resistance (IR) Limit @ 25°C
-55°C to +125°C
±30PPM/ºC
0%
250% of rated voltage
(5 ± 1 seconds and charge/discharge not exceeding 50mA)
0.1%
1000 megohm microfarads or 100GΩ
(Rated voltage applied for 120 ± 5 secs @ 25°C)
Parameters/Characteristics
To obtain IR limit, divide MΩ-µF value by the capacitance and compare to GΩ limit. Select the lower of the two limits.
Capacitance and Dissipation Factor (DF) measured under the following conditions:
1MHz ± 100kHz and 1.0Vrms ± 0.2V if capacitance ≤1000pF
1kHz ± 50Hz and 1.0Vrms ± 0.2V if capacitance >1000pF
Note: When measuring capacitance it is important to ensure the set voltage level is held constant. The HP4284 & Agilent E4980 have a feature known as Automatic
Level Control (ALC). The ALC feature should be switched to "ON".
Post Environmental Limits
High Temperature Life, Biased Humidity, Moisture Resistance
[size=4]I. Structural features [/size] [size=4]FPGA [/size] [size=4]a. There are a large number of logic gates and triggers in the chip, most of which are lookup table structures, and the implementati...
When I use Energia to download a program to MSP430, this error pops up saying that the device is not found. What's going on? usbutil: unable to find a device matching 0451:f432...
0 Introduction With the rapid development of information technology and the improvement of people's living standards, the development of medical electronic equipment has been greatly promoted. The dev...
As shown in the picture, I don't know what color I clicked and it turned green. It was all black before. This color looks too uncomfortable. I clicked the clear button in the lower right corner but it...
FD_ZERO( &fs ); FD_SET( sockM, &fs ); iRet = select( 0, &fs, NULL, NULL, &tv ); iRet value is 0. I checked and it said it was a timeout. Under what circumstances would this happen? I've been so depres...
Abstract: Aiming at the requirements of reducing wiring harnesses and lowering costs in automobile control systems, a car electric window control system designed with the PIC18F258 single-chip microco...
This paper designs a dot matrix LED text display screen that is easy to update, expandable, and low-cost. The way to reduce costs is
① Use the Bluetooth data transmission function of mobile ph...[Details]
5. Identifiers and keywords of C language
A complete PIC microcontroller C language program usually consists of six parts: include files (i.e. header files 1, variable definitions, variable de...[Details]
Editor's note: In order to help technicians or engineers who have knowledge of PIC microcontroller assembly language quickly master the method of using C language to program PIC microcontrollers, t...[Details]
PV inverter manufacturer SMA has launched its first DC arc fault circuit interrupter (AFCI) PV inverter and has received UL certification.
The new SunnyBoy AFCI inverter models include 3000-US...[Details]
The automotive lighting and signal control system is responsible for controlling the vehicle's lighting, signal lights, electric horns, reversing and brake buzzers. Traditional automotive lighting...[Details]
The typical fault troubleshooting listed below is for reference of maintenance personnel.
When the computer is turned on, the indicator light is off and there is no screen display
Mainte...[Details]
As a simple and practical input device, buttons have been used in various microcontroller application systems and are ubiquitous. However, the buttons used in different practical occasions are also...[Details]
Abstract: In recent years, with the establishment and grid-connected power generation of a large number of solar photovoltaic power stations at home and abroad, photovoltaic grid-connected inverter...[Details]
Spatial Division Multiplexing (SDM) MIMO processing can significantly improve spectrum efficiency and thus greatly increase the capacity of wireless communication systems. Spatial Division Multip...[Details]
LED light sources have many environmental advantages, but early products still have certain technical bottlenecks in heat dissipation and high brightness design that cannot be broken through....[Details]
At present,
the control system used in
automobiles
can be divided into three parts from the functional point of view:
sensor
unit, control unit and execution unit. Among them,
th...[Details]
The number of timers/counters and interrupt sources directly determines the performance of the microcontroller. The MCS-51 microcontroller has two programmable 16-bit timers/counters and five inter...[Details]
1 Introduction
Intelligent cars are the embodiment of the cross-integration of multiple disciplines such as automotive electronics, artificial intelligence, pattern recognition, automatic con...[Details]
AD7708 is a multi-channel 16-bit Σ-Δ analog-to-digital converter ADC. It supports 4 or 5 channels of true differential input and 8 or 10 channels of pseudo differential input. This chip allows two ...[Details]
The 8051 microcontroller is the most common microcontroller we have. I have been using 8051 for a long time and have also taught microcontroller courses for a period of time. Here I would like to s...[Details]
DSP and ARM Processors
京公网安备 11010802033920号
EEWORLD
