The properly and electrostatically measured taping materials are used for the components, but attention should be paid to the fact that there is some danger the parts absorb on the top
tapes to cause a failure in the mounting and the parts are destructed by static electricity (more than 1kV : 1J, 2A, 2B, 2E 0.5kV : 1E, Human Body Model 100pF 1.5kΩ) to change the
resistance in the conditions of an excessive dryness or after the parts are given vibration for a long time as they are packaged on the tapes. Similarly, care should be given not to apply the
excessive static electricity when mounting on the boards.
●
Ionic impurities such as flux etc. that are attached to these products or those mounted onto a PCB, negatively affect their moisture resistance, corrosion resistance, etc. The flux may
contain ionic substances like chlorine, acid, etc. while perspiration and saliva include ionic impurities like sodium (Na
＋
), chrorine (Cl
−
) etc. Therefore these kinds of ionic substances may
induce electrical corrosion when they invade into the products. Either thorough washing or using RMA solder and flux are necessary since lead free solder contains ionic substances.
Washing process is needed, before putting on moisture proof material in order to prevent electrical corrosion.
●
Please pay attention that the top of an iron does not direct touch to the components. There is a risk that may cause a change in resistance. Take care that another risk may happen that
the protecting coat is carbonized in an instant when touched directly by the top of the iron, also climatic-proof for electric corrosion or insulation of protecting coat may be dropped down.
Be sure not to give high temperature on the top of the iron as it will degrade the protecting coat.
●
Avoid storing components under direct sun rays, high temperature/humidity. Direct sun rays will cause quality change of taping and difficulty of keeping appropriate peeling strength. 5∼
35℃/35∼75%RH, there is no deterioration of solderability for 12 months, but take special care for storing, because condensation, dust, and toxic gas like hydrogen sulfide, sulfurous acid
gas, hydrogen chloride, etc. may drop solderability.
TI has a wide range of power supply products and a wide variety of models, which makes it difficult for novices to get started. Therefore, I hope experienced seniors can express their opinions and ins...
Xilinx official website provides a lot of low power design reference materials and software, shared here for your convenience! !
Xilinx 7 Series FPGA Power Estimation SoftwareXilinx Virtex5_Virtex6 se...
The following is the manual of the TDA7492PE power amplifier chip. The input voltage VCC is 12V. What are the functions of the D3, D4, D5, D6, D7, D8, D9, and D13 diodes? How to select them? Please gi...
[color=#333333]I would like to ask about the LabView industrial control equipment. When testing the product, the computer will automatically restart inexplicably. What is going on? It happens several ...
Homemade programmer: Use the parallel port pin 17 to trigger the counter to generate the address, the pin 16 to clear the address, the pin 14 to control the memory oe, and the pin 1 to control the mem...
CS5265 integrates a DP1.4 to HDMI2.0 converter . In addition, the CC controller is also used for CC communication to achieve DP Alt mode. Capstone CS5265 is a high-performance TYPEC/DP1.4 to HDMI2.0 c...
Analogue and Mixed Signal
京公网安备 11010802033920号
EEWORLD
