Note: A 0.01 Ohm addition to be added to the performance of all resistors <10 Ohms.
Pulse Performance Data
Lightning Surge
Lightning surge resistors are tested in accordance with IEC 60 115-1 using both 1.2/50µs and 10/700µs pulse shapes. 10 pulses are applied. The limit of
acceptance is a shift in resistance of less than 1% from the initial value.
2512
2010
1206
0805
0603
2512
2010
1206
0805
0603
General Note
TT Electronics reserves the right to make changes in product specification without notice or liability.
All information is subject to TT Electronics’ own data and is considered accurate at time of going to print.
The single impulse graph is the result of 50 impulses of rectangular shape applied at one minute intervals. The limit of acceptance was a shift in
resistance of less than 1% from the initial value.
2512
2010
1206
0805
0603
Continuous Load Due to Repetitive Pulses
The continuous load graph was obtained by applying repetitive rectangular pulses where the pulse period was adjusted so that the average
power dissipated in the resistor was equal to its rated power at 70°C. Again the limit of acceptance was a shift in resistance of less than 1% from the
initial value
2512
2010
1206
0805
0603
General Note
TT Electronics reserves the right to make changes in product specification without notice or liability.
All information is subject to TT Electronics’ own data and is considered accurate at time of going to print.
[p=28, 2, left][color=rgb(51, 51, 51)][font=宋体]Let's learn about several elements and important rules of EMC: [/font][/color][/p][p=28, 2, left][color=rgb(51, 51, 51)][font=宋体]Several elements of EMC ...
After the program is compiled without errors, I click the debug button to enter the debug interface and it runs immediately. I did not click the continuous run button. I have never encountered this si...
Why is there always no effect when writing infrared decoding with a low-frequency clock? The program is as follows: #define IR_sIG_Value P2IN & BIT0 void Infrared_Port_initialize() { P2DIR &=~BIT0; //...
10 clear classic circuits: 1. 150MHz frequency meter made of 2051 2. ADC function realized by IO port 3. USB to serial port - CH340 4. Making of serial port computer infrared remote control 5. Control...