EEWORLDEEWORLDEEWORLD

Part Number

Search

250X20L152B2CD

Description
Potentiometer, Carbon Composition, 0.05W, 1500ohm, 20V, 20% +/-Tol, 3935,
CategoryPassive components    The resistor   
File Size1MB,4 Pages
ManufacturerCTS
Environmental Compliance
Download Datasheet Parametric View All

250X20L152B2CD Overview

Potentiometer, Carbon Composition, 0.05W, 1500ohm, 20V, 20% +/-Tol, 3935,

250X20L152B2CD Parametric

Parameter NameAttribute value
Is it Rohs certified?conform to
Objectid838497464
Reach Compliance Codeunknown
Series 250
®
Commercial
Composition
9mm Diameter
Variable Resistors
• Miniature 9mm size
• Low cost
• Bushing mount or PC mount
• Dual control
• Detent available
Electrical and Mechanical Specifications
Resistance Range
Standard: 500 ohms through 1 megohms.
Special: For non-standard resistance values,
please contact CTS.
Resistance Tolerance
Standard: ±20%
Special: Tighter tolerances available
in most resistance values.
Resistance Taper
Standard: Linear
Special: Available
Power Rating
Single section - 0.05 watts @ 50°C derated to no load
@ 85°C for linear curve.
Dual section - 0.03 watts @ 50°C derated to no load
@ 85°C for linear curve.
Dielectric Strength
Withstands 250 VAC for 1 minute
Insulation Resistance
100 megohms minimum at 250 VDC
Maximum Operating Voltage
50 VAC, 20 VDC
Angle of Rotation
Total Rotation: 280° ± 5°
Rotational Torque
10-100 g-cm
Stop Strength
3kg-cm minimum
Detent
50% detent available in single section units
Pull-Push Strength
5kgf maximum
Rotational Life
Single seciton - 5K cycles
Dual section - 2K cycles
Slide Noise
Less than 100mV (measured by JIS C6443)
Gang Error
Within 3dB at –40 to 0 dB
Insertion Loss
0.1 dB maximum
Technical Data Sheet 1448C
Technical Data Sheet 1250
CTS CORPORATION /
MANUFACTURER OF RELIABLE ELECTRONIC COMPONENTS
TI High-Speed Signal Conditioning Product Selection Guide
[align=left][color=rgb(85, 85, 85)][font="][size=3] With the increase of communication capacity, the speed supported by device ports is getting higher and higher, from the common single-port 10Gbps an...
Jacktang Microcontroller MCU
The problem of microcontroller driving relay, is it redundant to add optocoupler?
Use a port of the microcontroller to connect an optocoupler TLP521, then the optocoupler is connected to the transistor, the transistor drives the relay, the right end of the relay and the optocoupler...
ttaid Analog electronics
Signal Processing Microcontroller and Applications Volume 1 PDF
The book Signal Processing Microcontroller and Application Volume 1 is quite good. Share it with me...
dengxiaoyang MCU
ds18b20
[i=s]This post was last edited by paulhyde on 2014-9-15 09:18[/i] ds18b20 ds18b20...
qshuangliang Electronics Design Contest
Is there such a DC-DC chip?
The input can withstand relatively large current, the input voltage is probably above 90V, and it is required to be able to step down to 12V (this voltage is used as power supply after adding filter c...
smartygt Analog electronics
Camera driver development under Linux
Anyone who has developed a camera driver under Linux, please come in and give me some advice! I used the open source Moto code to make it, and this problem always occurs, I2C-CAMERA in fun:i2c_ov9640_...
虾段 Linux and Android

EEWorld
subscription
account

EEWorld
service
account

Automotive
development
circle

Robot
development
community

Index Files: 1642  2535  1191  2078  77  34  52  24  42  2 
Datasheet   0 1 2 3 4 5 6 7 8 9 A B C D E F G H I J K L M N O P Q R S T U V W X Y Z
Room 1530, 15th Floor, Building B, No. 18 Zhongguancun Street, Haidian District, Beijing Telephone: (010) 82350740 Postal Code: 100190
Copyright © 2005-2026 EEWORLD.com.cn, Inc. All rights reserved 京ICP证060456号 京ICP备10001474号-1 电信业务审批[2006]字第258号函 京公网安备 11010802033920号