The company now has two products, one is ARM7 and the other is SyncMOS sm8958A. There is also an Atmel ATF1508AS on the board. Now I am asked to take over. Where should I start? I used to do software ...
When I used stm32 before, I was deeply impressed by the serial port debugging component of Atom, so I transplanted the component to test the serial port function debugging function.The Atom component ...
I use P1.7 of P1 port as interrupt, the falling edge is valid, and P1IFG is set to 0x80 when detected,but while(P1IFG&0X80) or while((P1IN&0X80)==0) cannot be used and cannot enter the loop.I can chan...
1. Micro-transmitting power: maximum transmitting power of 17dbm (50mW). 2. Operating carrier frequency 470-490MHz, no need to apply for frequency. 3. Professional industrial-grade embedded design, sm...
BCSCTL1 = XT2OFF; I use this statement to turn off XT2CLK, but why does XT2CLK still function as clock output after BCSCTL2 = SELM_2+ DIVM_0 + SELS + DIVS_0; instead of automatically switching to DOC ...
With the booming electronics industry, vision systems have become a leader in the electronics automation sector. However, the delicate nature of electronic products often affects product yields due...[Details]
On August 24th, media outlets reported, citing sources, that NavInfo, a listed company on the A-share market, is nearing completion in its acquisition of the intelligent driving c...[Details]
Zos Automotive Research Institute released the "2025
Smart Cockpit
Tier 1 Research Report (Domestic Edition)."
This report analyzes the operating conditions of more than a dozen ...[Details]
Since the beginning of this year, price wars have intensified, new models have been launched one after another, used cars with zero kilometers have become a hot topic, and the industry's internal c...[Details]
For autonomous vehicles to safely navigate the road, they must identify far more complex objects than just traffic lights, pedestrians, and other familiar objects. Among these obstacles is a crucia...[Details]
While the current industry consensus is that autonomous vehicles are robots and that their systems are managed using robotics-developed thinking, there are also cases where autonomous driving is ac...[Details]
Coal mines typically contain gas and coal dust. When gas and coal dust reach a certain concentration, they can cause explosions. Electrical equipment generates arcs during normal operation or durin...[Details]
Bosch has released a new SoC series to support L2+ advanced driver assistance functions. The chip integrates high resolution and long-range detection capabilities, and has built-in support for neur...[Details]
With the growth of the Internet of Things (IoT), wearable, and portable devices, consumers are growing weary of cluttered cables and the need for frequent battery recharges. The benefits of wireles...[Details]
As automotive technology develops at an ever-increasing pace, the performance requirements for automotive internal structures, components, and accessories are becoming increasingly demanding. The d...[Details]
Thoughts triggered by the Wuhan Radish Run incident
It's so hot, even Ferraris spontaneously combust. A recent incident on a Wuhan overpass: a red Ferrari...[Details]
1. Static Balance
Static balancing is performed on one correction surface of the rotor. The remaining unbalance after correction is used to ensure that the rotor is within the specified range ...[Details]
Electronic scales are a product of modern electronics development. Due to their simplicity, convenience, and high precision, they are widely used in various fields of industry and daily life. Based...[Details]
Sometimes an IAR project is closed abnormally. When you open the IAR project again, the project will not be displayed in the Workspace column, as shown in the following figure:
C...[Details]
The question of the benefits and drawbacks of DC and AC charging for electric vehicles is a common concern among electric vehicle users. Currently, there are two types of charging stations and meth...[Details]