-
introduction
1 The significance of using RTOS on MSP430
It is understandable that it is meaningless to use RTOS on MSP430. Because the hardware resources of MSP430 are limited (for exampl...[Details]
-
1 Introduction
Building Automation System (BAS) is a distributed monitoring system (DCS) designed according to distributed information and control theory. It is the result of the mutual de...[Details]
-
1 Introduction
With the development of control, computer, communication, network technology, etc., a new control technology, namely fieldbus, has emerged in the field of industrial control...[Details]
-
a. Keep the battery clean, wipe off the spilled electrolyte, contaminated dirt and dust in time; keep the poles and terminal clamps clean and in good contact, and apply vaseline or butter to preven...[Details]
-
Today's automotive application developers face numerous design challenges as modern cars add more electronic functionality, while the need for lower power consumption and smaller printed circuit bo...[Details]
-
Abstract: In a digital signal processing system with DSP as the core, analog-to-digital conversion is an important part of the system. Taking
TMS320C6203B and ADS5422 of
Texas Instruments
...[Details]
-
The ICLS60*X series ICs launched by Infineon contain four devices, namely ICLS6021J, ICLS6022J, ICLS6022G and ICLS6023J. This series of devices are suitable for building offline single-stage power fac...[Details]
-
Commonly used power management chips for portable products
●Low Dropout Regulators (LDO Linear Regulators)
LDO
VLDO;
●DC/DC Converters based on inductor energy...[Details]
-
1 Introduction
Today, as integrated circuit design technology has entered the fourth generation, an electronic system or subsystem can be fully integrated on a chip, that is, system-on-chip (SOC) in...[Details]
-
Last week, Microsoft's Windows Phone 8 system was launched with great fanfare and attracted much attention from the industry. However, Nokia, the most staunch supporter of Microsoft's Windows Phone sy...[Details]
-
Fragment velocity is an important parameter for evaluating the explosive effectiveness of warheads. Traditional range fragment velocity measurement systems mostly use multi-channel data acquisition...[Details]
-
With the development of communication technology, traditional analog walkie-talkies can no longer meet people's needs, and the digitization of walkie-talkies is imperative. The rapid development of...[Details]
-
Designing with FPGA, DSP or microprocessor is a critical part of the design and also takes the most time. System-level designers can benefit greatly by focusing their main efforts on system design, an...[Details]
-
1 Neutral point grounding method
In the early days, my country stipulated that the neutral point grounding methods of power systems should be divided into two categories: large grounding short...[Details]
-
The solution for system RF interface simulation analysis is:
(1) Use the ADS device library to select components such as mixers, bandpass filters, and power amplifiers;
(2) Determine the s...[Details]
Test/Measurement
京公网安备 11010802033920号
EEWORLD
