-
The problem of dynamic sealing of equipment always exists with the operation of the equipment. Today, we have specially sorted out the various commonly used sealing forms, usage scope and character...[Details]
-
1. Fault phenomenon and cause analysis
1. During the operation of the equipment, the expansion sleeve is subjected to a large torque, and the mating surfaces of the shaft and the sleeve move...[Details]
-
In the field of communications power supplies, AC/DC rectifier power supplies are called primary power supplies or basic power supplies, while DC/DC converters are called secondary power supplies. ...[Details]
-
01. Introduction
As in-vehicle networks migrate from the CAN
bus
to
Ethernet
, traditional millisecond-level synchronization accuracy can no longer meet the requirements of mul...[Details]
-
Generally not, but there are exceptions. For example, a torque motor controller with three-phase output voltage imbalance can cause current imbalance, similar to a phase loss. However, only two pha...[Details]
-
1. Static Balance
Static balancing is performed on one correction surface of the rotor. The remaining unbalance after correction is used to ensure that the rotor is within the specified range ...[Details]
-
summary
NFC (Near Field Communication) is a short-range, high-frequency wireless communication technology that allows contactless, point-to-point data exchange (within ten centimeters) between...[Details]
-
Sometimes an IAR project is closed abnormally. When you open the IAR project again, the project will not be displayed in the Workspace column, as shown in the following figure:
C...[Details]
-
The development of electric vehicles is unstoppable. More and more people are choosing new energy vehicles. With the subsidies provided by the state and the shortage of resources, new energy vehicl...[Details]
-
What is the difference in response time when the output uses cyclic refresh and direct refresh?
The time required from when the PLC receives an input signal to when the PLC outputs a con...[Details]
-
Quantum dots are a cutting-edge nanomaterial. Using quantum dot materials in backlight sources has four unique advantages:
1. Longer lifespan - Since mature inorganic materials are used, the f...[Details]
-
With the global penetration rate of new energy vehicles projected to exceed 45% by 2025, and the industry's transformation entering its second half, the era of intelligentization, LiDAR has rapidly...[Details]
-
1. One-way starting control circuit
1. Circuit operation analysis
1) Close the power switch QS and press the start button SB2. The contactor coil KM is energized, the normally open ...[Details]
-
As urbanization accelerates and public safety demands continue to rise, traditional surveillance systems are gradually exposing their limitations due to their reliance on manual oversight, delayed ...[Details]
-
Overview
1.1 Independent Advantages and Limitations of TSN and DDS
With
the continuous evolution of
intelligent
connected vehicles...[Details]
Embedded System
京公网安备 11010802033920号
EEWORLD
