logo Training

Electrical and Electronics (China University of Petroleum)

Total of 72 lessons ,2 days and 8 hours and 17 minutes and 13 seconds
Profile

Introduction to Electrical and Electronics Courses 1. Course Overview At present, electrical and electronic technology is widely used and developing very rapidly. It is increasingly penetrating into other subject areas to promote their development and plays an important role in my country's current economic construction. This course is a technical basic course for non-electrical majors. Its main task is to lay a solid theoretical foundation for electrical engineering technology for students to learn professional knowledge and engage in engineering and technical work, and to enable them to receive necessary basic skills training. Some of the material in this course is covered in physics courses. But while physics emphasizes concepts, this course emphasizes engineering applications.

Chapters
Unfold

You Might Like

Recommended Posts

Please guide me on chip selection
What chip should be used to convert triangle wave to sawtooth wave? The bandwidth should be between 1-10Mhz.
Bellaleaf NXP MCU
(Transfer) Design of isolated full-bridge DC-DC power supply
The full-bridge structure plays a wide role in circuit design. This paper introduces a design of isolated power supply based on full-bridge DC-DC. The half-bridge IGBT board mentioned in the paper has
qwqwqw2088
Lots of gadgets and information
I have browsed over 100 pages of forums these days and found them. I have sorted them out and downloaded what I need....:loveliness:
newbedeng MCU
A novice who just learned VHDL asks for advice on a program
There are four input data a, b, c, d. First, let A0=0, A1=0, and output y'0'); end if; en:='1'; end if; end if; if Aaa="01" then y'0'); end if; en:='1'; end if; end if; if Aaa="11" then y'0'); end if;
zimao1988 FPGA/CPLD
Low Power Design in Digital Signal Processing (DSP) Application Systems
With the increasing application of battery-powered systems, many systems, especially portable products, are facing the problem of low-power design, and DSP -based application systems are no exception.
feifei DSP and ARM Processors
How to overcome the challenge of aligning multiple connector groups between PCB boards
By: Kevin Meredith, Product Engineer, Samtec Printed circuit board (PCB) manufacturers are under significant pressure to increase density, shrink footprint, reduce form factor, manage thermal flow, an
eric_wang Integrated technical exchanges
Recommended Content

EEWorld
subscription
account

EEWorld
service
account

Automotive
development
circle

About Us Customer Service Contact Information Datasheet Sitemap LatestNews


Room 1530, 15th Floor, Building B, No.18 Zhongguancun Street, Haidian District, Beijing, Postal Code: 100190 China Telephone: 008610 8235 0740

Copyright © 2005-2024 EEWORLD.com.cn, Inc. All rights reserved 京B2-20211791 京ICP备10001474号-1 电信业务审批[2006]字第258号函 京公网安备 11010802033920号