Training

Location:Training / Embedded Development / System Design / Introduction to Computer Science and Programming / Introduction to Computer Science and Programming Episode 14

You can log in to your eeworld account to continue watching：
Introduction to Computer Science and Programming Episode 14
Login

Duration：50 minutes and 0 seconds
Date：2018/08/29

Uploader：老白菜

Introduction

keywords： programming computer

This course is intended for students with little or no programming experience. It strives to provide students with an understanding of the role of computers in problem solving and to help students, regardless of major, become fully equipped with the goal of completing useful small programs. confidence

You Might Like

Recommended Posts

Common Mistakes in Using QII: 1) When QuartusII performs timing simulation on the code, Error: Can't continue timing simulation because delay annotation information for design is missing. Reason: If you only need to perform functi; eeleader FPGA/CPLD

Reference salary for a master's degree in research and development: A summary of the salaries of major domestic companies in 2005 　　　　Japan's SONY 10,000/month, only graduate students are needed 　　　　　　South Korea's Samsung Electronics China headquarters 250,000/year; embgd FPGA/CPLD

How to view PWM waveform?: When using DSP, what do you use to view PWM waveforms? Oscilloscope or logic analyzer?; 安_然 Microcontroller MCU

????????????????????????: :@ I have been writing programs for MCU-MCU serial communication + keyboard scanning + digital tube display for so many days. I think the most important thing is to be careful. Computers are very pick; 天使疯子 Embedded System

Are you familiar with NOR Flash? Can flash with different speed grades be interchangeable?: This information comes from the cooperative QQ group: Electronic Engineer Technical Exchange (12425841) The group owner's ID in the forum: Kata --------------------------------------------------------; 船长 MCU

The serial port register UTXH cannot be written: Serial port settings: void init_uart() { GPHCON |= 0xa0; /* GPH2, GPH3 used as RXD0, TXD0*/ GPHUP = 0x0c; /* GPH2, GPH3 poll-up */ ULCON0 = 0x03; /* normal mode, no parity, one stop bit, 8-bit*/ UCON0; fangyu_99 Embedded System

Recommended Content

Hot VideosMore

Hot ArticlesMore

Circuit

可能感兴趣器件

EEWorld
subscription
account

EEWorld
service
account

Automotive
development
circle

About Us Customer Service Contact Information Datasheet Sitemap LatestNews

Room 1530, 15th Floor, Building B, No.18 Zhongguancun Street, Haidian District, Beijing, Postal Code: 100190 China Telephone: 008610 8235 0740

Copyright © 2005-2024 EEWORLD.com.cn, Inc. All rights reserved 京B2-20211791 京ICP备10001474号-1 电信业务审批[2006]字第258号函

京公网安备 11010802033920号