Training

Location:Training / Embedded Development / FPGA / Altera MAX 10 FPGA Analog Module Training / MAX 10 FPGA simulation module training

Chapter 1：MAX 10 FPGA simulation module training

Duration：10 minutes and 19 seconds
Date：2013/01/01

Uploader：EE资深网友

Introduction

keywords： FPGA The other Simulation module training

MAX 10 FPGA simulation module training. This training introduces how the ADC in MAX 10 FPGA works, how to configure it, and how to measure its performance in hardware.

You Might Like

Recommended Posts

[Lucky Building Grab] Design Your Own EEWORLD 1 - What DIY are you most interested in? (December 1st - December 31st): Many DIYs have been carried out in the forum, big or small. Each DIY may get strong support from some DIYers, and also gain a lot of experience. In order to better continue the DIY activities, I would; EEWORLD社区 Suggestions & Announcements

Counting Timing Help: Experts, I am a novice. I have a problem and I need your help and guidance. Thank you.In my FPGA design , there are two clock signals , one is 74.25MHz and the other is 400MHz. The period ratio of the; shangliyongzhe FPGA/CPLD

To jump, or not to jump? That is the question!: [color=#000][font=Arial, Helvetica, sans-serif, 宋体][size=12px]Dear friends, please help me analyze whether I should jump or not? The situation is as follows: [/size][/font][/color] [color=#000][font=A; 曹欢欢 Talking about work

Ask about LCD driver problem! !: When I use msp430f449 to drive the LCD directly, the display is very unstable (continuous flickering).I suspect it is a problem with the LCD timing, but I have tried all kinds of ACLK frequency divisi; dltskp Microcontroller MCU

12V lithium drill maintenance experience sharing: A 12V lithium-ion drill runs normally when idling, but cannot be loaded. Adjusting the tension gear does not work either. I tried to see if I could give it a try. It is better than throwing it away.Af; yjtyjt Making friends through disassembly

I have a problem with directshow. Directshow can usually read and display camere data normally.: I have a problem with directshow. Directshow can usually read and display camere data normally. When operating QR Code AP at high speed, in rare cases, the screen will go black when clicking "Barcode; wlck_8 Embedded System

Recommended Content

Hot VideosMore

Hot ArticlesMore

Circuit

可能感兴趣器件

EEWorld
subscription
account

EEWorld
service
account

Automotive
development
circle

About Us Customer Service Contact Information Datasheet Sitemap LatestNews

Room 1530, 15th Floor, Building B, No.18 Zhongguancun Street, Haidian District, Beijing, Postal Code: 100190 China Telephone: 008610 8235 0740

Copyright © 2005-2024 EEWORLD.com.cn, Inc. All rights reserved 京B2-20211791 京ICP备10001474号-1 电信业务审批[2006]字第258号函

京公网安备 11010802033920号