• Duration:1 hours and 18 minutes and 34 seconds
  • Date:2019/10/12
  • Uploader:老白菜
Introduction
keywords: robot control algorithm
Robots today move far too conservatively, using control systems that attempt to maintain full control authority at all times. Humans and animals move much more aggressively by routinely executing motions which involve a loss of instantaneous control authority. Controlling nonlinear systems without complete control authority requires methods that can reason about and exploit the natural dynamics of our machines.

This course introduces nonlinear dynamics and control of underactuated mechanical systems, with an emphasis on computational methods. Topics include the nonlinear dynamics of robotic manipulators, applied optimal and robust control and motion planning. Discussions include examples from biology and applications to legged locomotion, compliant manipulation, underwater robots, and flying machines.
Unfold ↓

You Might Like

Recommended Posts

LDMOS Transistor Durability and Reliability
Ruggedness is the most important reliability parameter in RF applications. NXP's 6th generation LDMOS transistors are almost indestructible. In a technical article titled " LDMOS Transistor Ruggedness
恩智浦半导体 RF/Wirelessly
There is a problem with the logic function, please help
[i=s] This post was last edited by pinggougou on 2015-5-24 01:21 [/i]As shown in the figure, the data received by the serial port is stored in the RAM block. Two RAM blocks are used here to complete t
pinggougou FPGA/CPLD
The difference between PLC transistor output and relay outputzz
1. Different load voltage and current types Load type: Transistors can only carry DC loads, while relays can carry both AC and DC loads. Current: Transistor current 0.2A-0.3A , relay current 2A . Volt
wdxyx Industrial Control Electronics
[Allwinner heterogeneous multi-core AI intelligent vision V853 development board evaluation] error: '%s' directive argument is null
This error occurs during buildroot compilation: gdbusauth.c:1302:11: error: ‘%s’ directive argument is null gdbusmessage.c:2702:30: error: ‘%s’ directive argument is null Solution: Add an if statement
dql2016 Domestic Chip Exchange
Design of high efficiency and high dimming ratio LED constant current drive circuit
Abstract: This paper proposes a wide voltage input, high efficiency, high dimming ratio LED constant current drive circuit. In the hysteresis current control mode, the circuit has the advantages of si
led2015 Power technology
wince iimage encoder
Has anyone implemented the encoder of wince iimage component? I am currently stuck on the implementation of IImageEncoder::GetEncodeSink( IImageSink** sink). I first CreateNewBitmap a bitmap and then
elehlw Embedded System

Recommended Content

可能感兴趣器件

EEWorld
subscription
account

EEWorld
service
account

Automotive
development
circle

About Us Customer Service Contact Information Datasheet Sitemap LatestNews


Room 1530, 15th Floor, Building B, No.18 Zhongguancun Street, Haidian District, Beijing, Postal Code: 100190 China Telephone: 008610 8235 0740

Copyright © 2005-2024 EEWORLD.com.cn, Inc. All rights reserved 京B2-20211791 京ICP备10001474号-1 电信业务审批[2006]字第258号函 京公网安备 11010802033920号