[i=s]This post was last edited by bjhyyq on 2017-7-19 11:35[/i] [align=left][size=14px][b]Preheating 1:[/b]Put the soldering tip in full contact with the solder joint. Figure 1 shows how to heat the s
I use IAR version 5.1, and the MCU model is MSP430F19. I can debug the software normally, but the following error will occur when the hardware is connected. The same error occurs when the MCU and emul
The following error occurs when compiling the program with CCS3.3: error: this declaration has no storage class or type specifier error: declaration is incompatible with "volatile struct PIE_CTRL_REGS
CC4024 is a 7-bit binary serial counter. All counters are slave flip-flops. The counter counts on the falling edge of the clock. When CR is high, the counter is cleared, because a tear-off flip-flop i
What is the function of the 10K ohm potentiometer connected to pins 34 and 56 in the figure? Why is it connected like this? Why are these four pins not listed in the simulation model on the official w
I spent two schematics at the beginning, and after I finished drawing the PCB, the schematics looked a bit messy, so I divided the schematics into several more according to the functions. However, I f