• Duration:24 minutes and 32 seconds
  • Date:2014/11/25
  • Uploader:dongcuipin
Introduction
keywords: Atmel AVR
 From the perspective of ease of use, low power consumption and high integration, Atmel AVR 8-bit and 32-bit microcontrollers complement Atmel ARM microcontrollers and microprocessors, fully embodying high performance, high power efficiency and design The perfect fusion of flexibility and other features. The solution uses the industry's most code-efficient architecture for C and assembly language programming and is optimized to accelerate time to market. No other microcontroller offers higher computing performance and better power efficiency. Industry-leading development tools and design support so you can get your products to market faster. The wide range of AVR products allows you to leverage your knowledge and experience when improving your products and opening up new markets - easily and cost-effectively.
Unfold ↓

You Might Like

Recommended Posts

[National Technology Low Power Series N32L43x Evaluation] 4. SPI-FLASH driver + fatfs file system transplantation + USB driver module...
[i=s]This post was last edited by emmnn on 2022-7-26 17:02[/i] [TOCM] # Preface It has been two weeks since the last post. Today I will mainly share the driver of W25Q128 SPI-FLASH and how to realize
emmnn Domestic Chip Exchange
PPP protocol advice
I am currently developing a system for sending MMS via a GPRS modem. I encountered some problems with PPP LCP verification and would like to ask for your advice. PPP messages are as follows: the first
solarissolaris Embedded System
Maximum acquisition time of F2812 built-in AD
I want to use all 16 AD channels in F2812 in an application. I plan to set it to synchronous mode and sample 2 channels at a time. If I set the sampling time, sampling window and other time quantities
wangBW Microcontroller MCU
A small question about the C language for microcontrollers?
Can anyone help me explain how to determine the software delay time in C51?
baijin0002 MCU
WinCE driver compilation problem
Hello everyone: I want to add a driver to an existing BSP. I already have the source code. My approach is: I directly copy the folder where the source code is located to the driver directory under the
waityou Embedded System
8051 kernel (vhdl)
[i=s] This post was last edited by paulhyde on 2014-9-15 03:37 [/i] FPGA embedded 51 core
yq_place Electronics Design Contest

Recommended Content

可能感兴趣器件

EEWorld
subscription
account

EEWorld
service
account

Automotive
development
circle

About Us Customer Service Contact Information Datasheet Sitemap LatestNews


Room 1530, 15th Floor, Building B, No.18 Zhongguancun Street, Haidian District, Beijing, Postal Code: 100190 China Telephone: 008610 8235 0740

Copyright © 2005-2024 EEWORLD.com.cn, Inc. All rights reserved 京B2-20211791 京ICP备10001474号-1 电信业务审批[2006]字第258号函 京公网安备 11010802033920号