Lemontree

LED driver with phase-cut dimming, 40 W

LED Driver with Phase-cut Dimmable Function, 40 W

Overview

The following reference design supports inclusion of FL7734MX in design of an LED Driver with Phase-cut dimmable function. It should be used in conjunction with the FL7734MX datasheet.

Documentation

LED Driver with Phase-cut Dimmable Function, 40 W

All reference designs on this site are sourced from major semiconductor manufacturers or collected online for learning and research. The copyright belongs to the semiconductor manufacturer or the original author. If you believe that the reference design of this site infringes upon your relevant rights and interests, please send us a rights notice. As a neutral platform service provider, we will take measures to delete the relevant content in accordance with relevant laws after receiving the relevant notice from the rights holder. Please send relevant notifications to email: bbs_service@eeworld.com.cn.

It is your responsibility to test the circuit yourself and determine its suitability for you. EEWorld will not be liable for direct, indirect, special, incidental, consequential or punitive damages arising from any cause or anything connected to any reference design used.

Hot

Technical Resources More

Search Datasheet?

Supported by EEWorld Datasheet

Technical Videos More

Forum More

Update:2025-06-26 04:17:51

CCD data package
Freescale's CCD camera for smart cars
The newly bought MSP430F5529 ez-fet doesn't even respond to the computer
[i=s]This post was last edited by .cn on 2014-3-31 00:51[/i] I just got in touch with the 430 microcontroller. I am still a novice. I would like to ask you a question: The board issued by the school w
Power supply dynamic response test, what kind of waveform is qualified?
[align=left]Dynamic response generally refers to the response of the output of a control system from the initial state to the final state under the action of a typical input signal. When a unit step i
[Agilent Essay] Agilent---You are my eyes
[i=s]This post was last edited by Xiaoqianbaibai on 2017-3-29 08:43[/i] [size=4]I am an intern and came to the capital from Changchun alone. I was lucky enough to get an internship in my current compa
AT+CMGS is very slow, why?
I use MC39i to send PDU SMS. It takes 3 or 4 seconds to show ">" during the AT+CMGS step. Why? Is there any way to speed it up? I have seen others use MC39i, but they can usually send it out within 1
[LPC54102] + Help with I2C interface
I want to use LPC54102 to drive a PCF8591 AD/DA module, but I can't figure it out. I hope an expert can give me some advice. PCF8591 uses the I2C bus interface to write the period address 0x90 (write

Datasheet More

Circuits More