newlandmark

VN7007ALH Evaluation Board

EV-VN7007ALH

Overview

This board provides you an easy way to connect STMicroelectronics^®VIPower^®M0-7 technology into your existing system.

Main features

Simple single IC application board dedicated for VN7007ALH
Provides electrical connectivity and thermal heat-sinking for easy prototyping
General device features
- Single channel smart high-side driver with CurrentSense analog feedback
- Very low standby current
- Compatible with 3 V and 5 V CMOS outputs
Diagnostic functions
- Dedicated high precision proportional load current sense
- Overload and short to ground (power limitation) indication
- Thermal shutdown indication
- OFF-state open-load detection
- Output short to VCC detection
Protections
- Undervoltage shutdown
- Overvoltage clamp
- Load current limitation
- Self limiting of fast thermal transients
- Loss of ground and loss of VCC
- Configurable latch-off on overtemperature or power limitation
- Reverse battery
- Electrostatic discharge protection

Design Files

VN7007ALH Evaluation Board

All reference designs on this site are sourced from major semiconductor manufacturers or collected online for learning and research. The copyright belongs to the semiconductor manufacturer or the original author. If you believe that the reference design of this site infringes upon your relevant rights and interests, please send us a rights notice. As a neutral platform service provider, we will take measures to delete the relevant content in accordance with relevant laws after receiving the relevant notice from the rights holder. Please send relevant notifications to email: bbs_service@eeworld.com.cn.

It is your responsibility to test the circuit yourself and determine its suitability for you. EEWorld will not be liable for direct, indirect, special, incidental, consequential or punitive damages arising from any cause or anything connected to any reference design used.

Hot

Technical Resources More

Search Datasheet?

Supported by EEWorld Datasheet

Technical Videos More

Forum More

Update:2025-05-09 13:27:35

Confusion and test report about Bluetooth speed
The Bluetooth adapter BTH v2.0 + EDR on the market claims that the maximum data rate can reach 3Mbps. In our project, we used a Bluetooth module from a small company with a CSR chip. The UART baud rat
Are you all using wince6.0 for development now?
Are you all using wince6.0 for development now? Where can I find a development board that supports BSP6.0?
How does TMS320C6678 achieve 500Mbps GbE performance?
Recently, I am debugging DSP6678 Gigabit Ethernet communication, hoping to achieve a communication rate of 500Mbps; I used two methods to test, and found that the communication rate was not high: 1. U
TFT screen display under high and low temperature environment
The device has no problem at normal temperature, and there is no problem at low temperature of -10 degrees, but at 60 degrees, the LCD display has a distorted screen. [b]Normal display logic[/b] [list
Do both parties in 485 communication need a ground wire?
I saw this sentence on the Internet: The ground potential difference between the two sides of RS-485 communication is required to be less than 1V.I measured the ground potential difference between my
My socket data transmission problem
Dear experts, I am going crazy. I am using socket to communicate with PC on Arm7 development board. Arm7 receives string from PC iRecv=recvfrom(ClientSock_in, (char *)RecvData, 8, 0, (struct sockaddr*

Datasheet More

Circuits More