宋元浩

USBMLCF: USB ColdFire Multlink

Overview

P&E’s USB ColdFire^® Multilink is an easy-to-use debug and programming interface for the ColdFire V2/V3/V4 line of MPUs.

The USB ColdFire Multilink is supported by P&E software, Our CodeWarrior^®, and other 3rd-party software (available separately). P&E’s ColdFire In-Circuit Programmer can be used with the Multilink to program flash memory devices. The USB ColdFire Multilink also works with P&E’s ColdFire In-Circuit Debugger to control the target processor’s execution, read/write registers and memory, and perform full C source-level debug.

NOTE: The USBMLCF interface is being discontinued and replaced by the U-MULTILINK-FX interface.

MoreCollapse

Documentation

All reference designs on this site are sourced from major semiconductor manufacturers or collected online for learning and research. The copyright belongs to the semiconductor manufacturer or the original author. If you believe that the reference design of this site infringes upon your relevant rights and interests, please send us a rights notice. As a neutral platform service provider, we will take measures to delete the relevant content in accordance with relevant laws after receiving the relevant notice from the rights holder. Please send relevant notifications to email: bbs_service@eeworld.com.cn.

It is your responsibility to test the circuit yourself and determine its suitability for you. EEWorld will not be liable for direct, indirect, special, incidental, consequential or punitive damages arising from any cause or anything connected to any reference design used.

Hot

Technical Resources More

Search Datasheet?

Supported by EEWorld Datasheet

Technical Videos More

Forum More

Update:2025-08-09 18:04:58

What is iPhone USB PD fast charging?
The new generation of iPhone 8 / iPhone 8 Plus / iPhone X that supports PD fast charging has appeared. Although most consumers know that iPhone already supports fast charging, and major media have als
About the problem of reducing the sampling rate of ad62p49
I am now using the ads62p49 chip to implement 8-channel AD synchronous input, and the AD9516 chip to output the LVDS clock, and then connected to the FPGA through the FMC interface. The demo program I
HC8819 data, the step-down chip found when disassembling the car charger
This car charger was given to me by someone else. It is of good quality and should be a relatively cheap one. I changed it after using it for a while because of poor contact. Now the new one I bought
NS introduces 1MHz synchronous buck switching controller
National Semiconductor (NS) has announced a 1MHz synchronous buck switching controller that can drive up to 10A loads in an ultra-small [b][/b][url=http://www.dzsc.com/icstock/504/MSOP.html][b]MSOP[/b
F2802X serial port download problem
I recently used codeskin to download via serial port, and it was successful. But there is a problem that really makes me scratch my head.To use the serial port to download the program, GPIO47 and GPIO
0x8989 LCD driver controller
The DeviceCode read out from my LCD module debugging is 0x8989. The CD contains the data of ili9320. I compared some register statements in the routines with the commands in the ili9320 manual. Some o

Datasheet More

Circuits More