newlandmark

KITVR5500AEEVM: VR5500/FS5502 PMIC Evaluation Board

Overview

The KITVR5500AEEVM provides the flexibility to use all features of this device and perform measurements in the main part of the application. The KL25Z MCU installed on the board combined with the FlexGUI software allows access to the registers in read and write modes. All voltage regulators are accessible via connectors. Non-user signals, such as DC/DC switching nodes, are mapped to test points.

The board can operate in emulation or OTP mode. In emulation mode, the board configuration remains valid as long as power is supplied. OTP mode uses fuse configuration.
Target applications

Mid to High Infotainment/eCockpit
Entry-level automotive infotainment system/Networked radio
Automotive vision system

Blockdiagram

Design Files

KITVR5500AEEVM Gerber Files and BOM

Documentation

All reference designs on this site are sourced from major semiconductor manufacturers or collected online for learning and research. The copyright belongs to the semiconductor manufacturer or the original author. If you believe that the reference design of this site infringes upon your relevant rights and interests, please send us a rights notice. As a neutral platform service provider, we will take measures to delete the relevant content in accordance with relevant laws after receiving the relevant notice from the rights holder. Please send relevant notifications to email: bbs_service@eeworld.com.cn.

It is your responsibility to test the circuit yourself and determine its suitability for you. EEWorld will not be liable for direct, indirect, special, incidental, consequential or punitive damages arising from any cause or anything connected to any reference design used.

Hot

Technical Resources More

Search Datasheet?

Supported by EEWorld Datasheet

Technical Videos More

Forum More

Update:2025-06-20 08:25:47

How to achieve the timing between two pulses
The motor I use sends a pulse when it rotates once. I want to know how to get the time interval between two pulses and thus the speed of the motor.
A brief introduction to VFD
A brief introduction to VFD
LINK: fatal error LNK1181: cannot open input file 'libcpmt.lib'
The libcpmt.lib in the compilation result is not found in the EVC installation directory
Ask a question about hardware filtering
It's my final project. I have to do a signal amplification problem. The signal comes out of the sensor, and I have a differential amplifier. After the differential, there is another amplifier. There i
How to use LCD to dynamically display floating point data?
As the title says, thank you!
LPC2378 pins cannot be set to high or low levels, no waveform
[b][color=#333333][backcolor=rgb(245, 245, 245)][font=Helvetica, Tahoma, Arial, sans-serif]1. Programming software KEIL4[/font][/backcolor][/color] [color=#333333][backcolor=rgb(245, 245, 245)][font=H

Datasheet More

Circuits More