supremeOne

Laowang ETC-OLED AND 0.88OLED screen adapter board

Overview

Laowang ETC-OLED AND 0.88OLED screen adapter board
12864 OLED and 12832 OLED
I2C interfaces have different screen addresses and just hang on a set of I2C.

The effect is as follows, the shooting is a bit flashy.

https://www.bilibili.com/video/BV1rJ411L7n7

Design Files

All reference designs on this site are sourced from major semiconductor manufacturers or collected online for learning and research. The copyright belongs to the semiconductor manufacturer or the original author. If you believe that the reference design of this site infringes upon your relevant rights and interests, please send us a rights notice. As a neutral platform service provider, we will take measures to delete the relevant content in accordance with relevant laws after receiving the relevant notice from the rights holder. Please send relevant notifications to email: bbs_service@eeworld.com.cn.

It is your responsibility to test the circuit yourself and determine its suitability for you. EEWorld will not be liable for direct, indirect, special, incidental, consequential or punitive damages arising from any cause or anything connected to any reference design used.

Hot

Technical Resources More

Search Datasheet?

Supported by EEWorld Datasheet

Technical Videos More

Forum More

Update:2025-06-14 05:29:48

Design of wireless remote control LED clock screen
[b]Introduction[/b] The long-term use of LED clock display will produce a certain cumulative error, so it needs to be corrected after a period of use. However, large-screen clock displays are usually
Added a supercapacitor to the pyboardCN
[i=s]This post was last edited by dcexpert on 2018-4-7 18:06[/i] In order to test the function of RTC, a super capacitor was added to the first version of pyboardCN to power VBat. A 0.22F super capaci
Addition and Multiplication in FPGA Design
In FPGA design, addition, subtraction, and multiplication are described using Verilog HDL language. It is very simple, directly +, -, *, without any doubt, but the bit width of the signal in the calcu
The first article introduces Ansys software
[size=2]I have played with Ansys software for a few days and found it quite interesting and helpful. Judging from the online charges, it is also good for commercial use. In the following articles, I w
Altera board JTAG cannot burn program
[i=s] This post was last edited by ligongxiaobie on 2014-10-31 10:35 [/i] [color=#ff0000] Now a new phenomenon has appeared. A board can be programmed using JTAG. CONF_DONE is also set high, and the n
Route Binding
Hello everyone, when I modify the route binding program, it always shows "Match Desc Req", "Non Matched", and no match is found. Can you provide me with some advice?

Datasheet More

Circuits More