他们逼我做卧底

ATtiny13A development board

Overview

The ATtiny13A development board is compatible with other 8-pin microcontrollers in the tiny series, such as tiny25/45/85. Most components use plug-ins and are designed with chip-compatible pads.

Tiny13A pad is compatible with wide body SOP8, SOIC8 and DIP8 packages. DIP8 package needs to be soldered on the reverse side;
There is no serial port conversion interface designed and an external serial port cable is required;
Use six-pin ICSP interface programming, the same as arduino;
AMS1117 power supply circuit;
Half-duplex serial port circuit, used to realize single-line bidirectional soft serial port;
595 module, use the jumper cap to select whether to enable it;
595 static driven digital tube, 5.6 inches common anode. Use a jumper cap to select whether to enable it;
595 pad is compatible with SOP16 and DIP16 packages;

routine

Flash and static digital tube driver: tiny13A-blink

Design Files

All reference designs on this site are sourced from major semiconductor manufacturers or collected online for learning and research. The copyright belongs to the semiconductor manufacturer or the original author. If you believe that the reference design of this site infringes upon your relevant rights and interests, please send us a rights notice. As a neutral platform service provider, we will take measures to delete the relevant content in accordance with relevant laws after receiving the relevant notice from the rights holder. Please send relevant notifications to email: bbs_service@eeworld.com.cn.

It is your responsibility to test the circuit yourself and determine its suitability for you. EEWorld will not be liable for direct, indirect, special, incidental, consequential or punitive damages arising from any cause or anything connected to any reference design used.

Hot

Technical Resources More

Search Datasheet?

Supported by EEWorld Datasheet

Technical Videos More

Forum More

Update:2025-07-04 10:06:55

TMS320C6748_UART(2) - Initialization Configuration
1. UART structure　　UART2 input clock is PLL1_SYSCLK2, PLL1_SYSCLK2 is PLL1_SYSCLK1 divided by 2, the frequency of PLL1_SYSCLK1 is 456MHz by default, the PLL clock tree is as shown in the figure:(Guide
[Share] 12 golden rules for success before the age of 35
12 golden rules for success before age 35Chapter 1: A goal? For a ship without a sailing goal, any wind from any direction is a headwind. 1. The first reason why you are poor is that you have not set
The basic working principle of the hydraulic brake system using hydroforming technology
[i=s]This post was last edited by Xingdiyuan Machinery on 2019-8-6 14:28[/i]Speed has given cars new life, but today, our cars still cannot reach the ultimate speed. Why is this? With current technolo
Question E, please enter
[i=s] This post was last edited by paulhyde on 2014-9-15 09:30 [/i] Let's discuss and communicate...........
Light-up Bubble Clock Using ESP8266
From: https://www.instructables.com/id/Glowin ... y-ESP8266/The "Glowing Bubble Clock" displays time and patterns through bubbles in the liquid. Unlike the LED matrix display, the slowly drifting, glo
Share: Actual case of switching power supply EMI rectification
[i=s]This post was last edited by qwqwqw2088 on 2018-7-19 09:12[/i] [size=4]This is a power supply with a wide input voltage of 120-277V 60HZ, an output of 48V, 273mA, and a Buck topology. [/size] [al

Datasheet More

Circuits More