他们逼我做卧底

nuedc2020_lmt70

Overview

An LMT70 + ADS1113 16bit ADC is used to form a temperature detection system with an accuracy of 0.1°C. The system uses I2C bus interface and 5V power input (to avoid power supply noise interference)

Design Files

All reference designs on this site are sourced from major semiconductor manufacturers or collected online for learning and research. The copyright belongs to the semiconductor manufacturer or the original author. If you believe that the reference design of this site infringes upon your relevant rights and interests, please send us a rights notice. As a neutral platform service provider, we will take measures to delete the relevant content in accordance with relevant laws after receiving the relevant notice from the rights holder. Please send relevant notifications to email: bbs_service@eeworld.com.cn.

It is your responsibility to test the circuit yourself and determine its suitability for you. EEWorld will not be liable for direct, indirect, special, incidental, consequential or punitive damages arising from any cause or anything connected to any reference design used.

Hot

Technical Resources More

Search Datasheet?

Supported by EEWorld Datasheet

Technical Videos More

Forum More

Update:2025-05-13 09:26:19

LED Timer Keychain
Source: https://www.hackster.io/atul-john-abraham/timer-based-led-keychain-48acadTimer Based Led Keychain. The keychain has an IC-555 which controls the blinking time of two LEDs. The 555 timer IC is
RF Broadband Amplifier (Topic D) Solution
[i=s]This post was last edited by paulhyde on 2014-9-15 03:00[/i] Our solution cannot reach very high targets, but more than 100M is still easy. The advantage of the solution is that it uses IC, which
EDMA interrupt problem of C6416
Use timer 0 to trigger EDMA events, send a set of data in the memory to SDRAM, call EDMA interrupt to move the data to the memory. Data can be sent to SDRAM, but EDMA interrupt cannot be entered. What
RF2051 chip
RF2051 9pin MODE Mode select pin. An RC low-pass filter can be used to reduce digital noise.Can this pin 9 be disconnected?
Ask about the tinning of bare boards
[font=微软雅黑][size=4]As the title states[/size][/font] [font=微软雅黑][size=4] [/size][/font] [font=微软雅黑][size=4]How to tin a bare board/bare board? The board has been coated with solder mask ink but the co
[Repost] Analysis of transistor level conversion and driving circuit
As shown in the figure above, the left end is connected to the 3.3V CMOS level, which can be the IO port of STM32, FPGA, etc., and the right end outputs 5V level, realizing the conversion from 3.3V to

Datasheet More

Circuits More