newrudeman

Second PCB modification

Overview

After the second revision under the guidance of Giftina , I am very grateful to the guide. It took more than a month initially due to lack of time, but the final effect is still very satisfactory.

Complete picture:

Design Files

All reference designs on this site are sourced from major semiconductor manufacturers or collected online for learning and research. The copyright belongs to the semiconductor manufacturer or the original author. If you believe that the reference design of this site infringes upon your relevant rights and interests, please send us a rights notice. As a neutral platform service provider, we will take measures to delete the relevant content in accordance with relevant laws after receiving the relevant notice from the rights holder. Please send relevant notifications to email: bbs_service@eeworld.com.cn.

It is your responsibility to test the circuit yourself and determine its suitability for you. EEWorld will not be liable for direct, indirect, special, incidental, consequential or punitive damages arising from any cause or anything connected to any reference design used.

Hot

Technical Resources More

Search Datasheet?

Supported by EEWorld Datasheet

Technical Videos More

Forum More

Update:2025-08-04 18:01:03

Give me some ideas, everyone.
A few questions: 1. Is the prospect of embedded system good? How is the salary? 2. Doesn't embedded system engineer have a bottleneck at 35 years old? 3. I am a student, I want to know how much the tr
LWIP DHCP Issue
As shown in the figure, Cannot use this netif with DHCP: MTU is too small, what does it mean, how can I make the network not too small?
ARM7 interrupts are confusing? Could any expert help me? I'd be grateful!
I wrote a timer interrupt program under ARM7. The following code is to switch to system mode after entering IRQ interrupt, so as to make the interrupt reentrant. But there is a problem when switching?
EZ430——RF2500 Learning Tips
I just got a 430 recently. I only used 51 before. But since most of the programs for 430 are written in C, it is relatively easy to learn. I have been learning about the output of uart in the past few
Share a cracking program and method of IAR for MSP430 6.2
Share a cracking program and method of IAR for MSP430 6.2
Some tips on interrupt nesting
Interrupt nesting, the control bit of the priority 430 general interrupt is the GIE bit in the status register (this bit is in the SR register ). When this bit is in the reset state , all maskable int

Datasheet More

Circuits More